Instruction manual

11
eN
Instruction Manual

• Take the appliance andaccessoriesoutthebox.Removethe stickers,protective
foilorplasticfrom thedevice.
• Place the device on a flat stable surface and ensure a minimum of 10 cm. free
space around the device. This device is not suitable for installation in a cabinet or
for outside use.
• You can power your portable system by plugging the detachable AC power cord
into the AC inlet at the back of the unit and into a wall AC power outlet. Check
that the rated voltage of your appliance matches your local voltage. Make sure
that the AC power cord is fully inserted into the appliance.
• This set has a built-in power saving system which will automatically put the set
into a "standby mode" when it detects that the set is not in use.
• Connect the audio and lightning cable of the speakers in the designated sockets
on the back of the unit, please make sure you'll insert the gold audio cable in the
red socket.


• The clock will be displayed in standby mode and when you press the "time/
snooze" key.

• Switch the unit to standby mode press and hold the "time/snooze" key to get in
the setting mode. Now use the "tune +" and "tune -" key on the remote control
to set the desired setting, confirm with the "time/snooze" key and follow the
procedure.

• Press the "sleep" key repeatedly to choose the automatic power OFF time.

• Press and hold the "night" key for 2 seconds to switch on and off the display
backlight.

• Press the "EQ/bass" key repeatedly to choose the desired sound effect according
to the music you're listening.

• Press and hold the "EQ/bass" key to switch to bass boost function on or off.

• Press the "function" key repeatedly to choose the radio function.
• Press the "tune +" and "tune -" key to scan manually.
• Press and hold the "tune +" and "tune -" key for two seconds to scan
automatically.
• Press the "prog." key to store the current station. Use the "mem + and -" key's to
choose the desired memory position and confirm with the "prog." key.

• Press the "function" key repeatedly to choose the CD function.
• Press the "open/close" key to open the CD door, place a cd or MP3 onto the centre
spindle with the label side facing upwards. Close the CD door by pressing the
"open/close" key and the first track will start playing.
• For MP3 CD's you can use the "folder + and -" key to choose the required folder.

• Press the "function" key repeatedly to choose the USB or SD function.
• Insert the USB flash drive or SD card and you can start playback.
• Note: SD card (for MP3 playback) support SD (up to 16GB).
• Note: USB (for MP3 playback) support USB 1.1/2.0 (up to 16GB).
• Note: always press "stop" and then press "function" to switch to another source
before removing USB or SD.