Owner's Manual
AMP100VS
OWNER'S MANUAL
APPLICATIONS
STEREO SETUP
In
this configuration, the mode switch is set to "Stereo". Connect the line out jacks
from a stereo
pre-amplifier or source to the MAIN input jacks
of
your AMP100VS.
Next connect your speakers to the terminals marked "Speaker A" observing
proper
polarity. Select the "A" speakers using the front
panel
zone selection
buttons. Connect a second (optional) pair
of
speakers
to
the terminals marked
"Speaker
B".
If you are connecting 4 speakers to the AMP100VS they must be
8 ohm speakers
only. Press A
and
B together to use
both
zones.
Use these
Inputs
to
connect
Pre-amp
or
Receiver Line Out
SETUP FOR MULTIPLE SOURCE
In the multiple source set up, a distributed audio system is connected to the
AMP1
OOVS
as
a local zone amplifier via the MAIN inputs. Normally the distributed
audio system
will
be
the audio source for the
AMP1
OOVS.
The distributed audio
is
then passed
on
to be used by additional zones
or
sub zones in the distributed
system via the
MAIN
outputs.
Connect
Local Source
Line Out here (such
as
.mp3 player)
Line Out to
Additional Zones
Use these Inputs to connect
Pre-amp
or
Receiver Line Out
The audio output
of
a local source, such as an MP3 Player, CD, television,
computer,
etc.,
is connected to
the
AMP100VS via the INTERRUPTING inputs, and
whenever the
local source is active its signal will take priority over the
distributed audio
signal present
at
MAIN
input . However, the distributed audio signal
will still
be
present at the MAIN input. In this circumstance the audio output of the
local source will be heard via the AMP1
OOVS
. Once the local source is turned
off
or
muted, the
AMP1
OOVS
will automatically switch back
to
the distributed audio
system
as
an
audio source, assuming the local source remains inactive. There
is a
delay of up to 6 seconds when switching from INTERRUPTING input back
to
MAIN inputs.
Limited Warranty
AudioSource® warrants its amplifier products against defects in materials
and workmanship
for
a limited period
of
time.
For
a period
of
two years from
date
of
original purchase,
we
will repair
or
replace the product,
at
our
option,
without charge for parts and
labor. Customer must pay all parts and labor
charges after the limited warranty period expires. The limited warranty period
for factory refurbished products expires after ninety
(90)
days
from date
of
original purchase.
This
limited warranty applies only
to
purchases from authorized AudioSource®
electronics retailers. This limited warranty is extended only to the original
purchaser and is valid only
to
consumers in the United States.
Consumers are required to provide a copy
of
the original sales invoice from
an authorized AudioSource®
dealer when making a claim
against this limited
warranty. This limited warranty only covers failures due to defects in materials
or
workmanship that
occur
dur
ing normal use.
It
does
not
cover failures
resulting
from
acc
ident, misuse, abuse, neglect, mishandling, misapplication,
alteration, faulty installation,
modification, service by anyone other than
AudioSource®,
or
damage that is attributable
to
Acts
of
God. It does not
cover costs
of
transportation to AudioSource®
or
damage in transit.
The
customer should return his defective product, freight prepaid and insured,
to
AudioSource® only after receiving a Return Authorization.
This warranty
will become void
if
the serial number identification has been
wholly
or
partially removed, altered
or
erased. Repair
or
replacement under
the terms
of
this warranty does not extend the terms
of
this warranty. Should
a product prove
to
be
defective in workmanship
or
material, the consumer's
sole remedies will be repair
or
replacement
as
provided under the tenms
of
this warranty.
Under
no circumstances shall AudioSource® be liable for
loss
or
damage, direct, consequential
or
incidental, arising out
of
the use
of
or
inability
to
use the product. There are no express warranties other than
described above.
•
AudioSource
13Qf0 SIV U r c i\ 1
('
Po
r
tl
.;nd
OR
91703 . 503
91
4
16
8ti •
w."v
e
ud
ro
SC
J '( C not