Owner's Manual

ManualsBrandsAudioSource ManualsHome AudioAMP1200VS

OWNER’S MANUAL

AMP1200VS

AudioSource®

13970 SW 72nd Ave

Portland, OR 97223

503.914.4688

www.audiosource.net

AMP1200VS Owner’s Manual 72015

Congratulations on your purchase of the AudioSource® AMP1200VS.

Please take a few moments to read this entire manual, and be sure to

retain this document for future reference. Please read and observe all

safety instructions detailed on page 2.

NOTE: If any part of this product is damaged or missing, please call your

dealer or AudioSource® directly at 1.877.715.5439 or 503.914.4688.

Please read your warranty and retain your receipt and original carton

for possible future use.

For more information about AudioSource® electronics, speakers and

accessories please visit www.audiosource.net

FEATURES:

SPECIFICATIONS

Stereo (8 ohm): 12 x 40W per channel, <0.2% THD+N

Stereo (4 ohm): 12 x 40W per channel, <0.2% THD+N

Bridged Mono (8 ohm): 80W, 1kHz, <0.2% THD+N

Frequency Response: 10Hz ~ 50kHz, +0dB/ -3dB

Signal to Noise Ratio:

100dB below 150W output into 8 ohms

Channel Separation: 70dB @ 1kHz, referred to 150W output

into 8 ohms

Input Sensitivity: Variable, 350mV to 2.8V for rated power

into 8 ohms

AC Power Consumption: 1000W maximum

Net Weight: 30lbs / 13.6kgs

Gross Weight: 36lbs / 16.3kgs

Multi-Zone Power Amplifier

AMP1200VS

12 Independent Channel inputs, 2 Buss Inputs

2 Buss Outputs

Independent Channel Gain Controls

Manual, Auto, or Triggered On/Off Modes

Bridgeable Channel Outputs

Rack Mountable (Rack Mount Included)

LED Status Indicator Lights

Phoenix-Style Speaker Connectors

Stable Class A/B Design

Extensive Protection Circuitry

4.0”

(102mm)

16.5” (419mm)

14.25”

(361mm)

-5,4):/.%0/7%2!-0,)&)%2

AMP1200VS

Summary of content (5 pages)

PAGE 1
AMP1200VS OWNER’S MANUAL AMP1200VS Multi-Zone Power Amplifier FEATURES: 12 Independent Channel inputs, 2 Buss Inputs 2 Buss Outputs Independent Channel Gain Controls Manual, Auto, or Triggered On/Off Modes Bridgeable Channel Outputs Rack Mountable (Rack Mount Included) LED Status Indicator Lights Phoenix-Style Speaker Connectors Stable Class A/B Design Extensive Protection Circuitry Congratulations on your purchase of the AudioSource® AMP1200VS.
PAGE 2
AMP1200VS OWNER’S MANUAL CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL! The exclamation point within an equilateral triangle is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
PAGE 3
AMP1200VS OWNER’S MANUAL AMP1200VS -5,4) :/.% 0/7%2 !-0,)&)%2 2 1 Figure 1. Front Panel FRONT PANEL CONTROLS 1. Master Power Switch / Indicator LED Front panel pushbutton power switch turns the ampliﬁer on and off. When the switch is on and the indicator LED is red, the ampliﬁer is in standby mode. The remote turn on switch (located on the rear) is either in the “trigger” or “auto” position. When the LED is blue, the ampliﬁer is fully active.
PAGE 4
AMP1200VS OWNER’S MANUAL 490)#!, 2//- ).34!,,!4)/. AM/FM RECEIVER Limited Warranty NOTES ABOUT HUM: While the AMP1200VS has been designed to minimize the possibility of hum in the audio system, it is still possible that a hum will occur in rare circumstances. Its safety grounding can create a path for small amounts of 60 Hz energy to travel trough the line-level audio system.
PAGE 5
Thank you for purchasing your Audiosource amplifier from Crutchfield. The manufactures warranty for this amplifier is 2 years, however thanks to our partnership with Audiosource, this has been extended by Audiosource to 3 years from the original date of purchase. During this timeframe Crutchfield will, at Crutchfield’s sole discretion, exchange the amplifier if it is found to be defective.