Owner's Manual . Audio Source EQ 200 l Ten-Band Stereo Graphic Equalizer with Spectrum Analyzer Display Congratulations on your new purchase, and welcome to the Audio Source family of satisfied customers. We trust that you will continue to enjoy the value and quality of your Audio Source EQ 200 Stereo Graphic Equalizer. In order to make sure that you are experiencing the best performance from your unit, please take a few moments to read this manual before you get started.
WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. RISK OF ELECTRIC SHOCK, DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of insulated "dangerous voltags® within the product's enclosure that may be of sufficient magnitude to constitute a risk of electrical shock 60 persons.
i g A Few Words About Graphic Equalizers Thank you for choosing this Audio Source EQ 200 Graphic Equalizer, Used correctly, a Graphic Equalizer is a powerful tool for very detailed control over the sound of your speakers, far more than available from simple tone controls. With the EQ 200, you can enhance the sound of older recordings, alter instrumental and vocal balance to suit your own tastes, make "Custom Equalized" recordings, and a multitude of other uses.
e Mot ety Using The Controls Power : Press this button to activate the power on the EQ 200. The LED will be green ° to show power is "On”. Push the button again to turn "Off" the EQ 200. The LED will Power be red to show this selection. Tape 2-1: This button allows you to make a tape copy or "Dub" between the two cassette decks, Press this button "Tn" to “Dub" from Tape 1 to Tape 2. The LED will ° be green to show this selection. Leave this button in the "Out” position to "Dub" from Tape 2 to Tape 1.
t Carol s e ECUADOR R Left Level, or Right Level LETTERER Coder Using The Controls Level Controls: Both left and right channels have a control marked "Level”. This controls the level, or volume of each channel. Usually, these controls can be set to their maximum position, but these levels can be reduced if an overly strong input signal causes distortion, Usually, similar adjustments should be made for both channels, EQ Sliders : Each of these sliders will give 12Db. of "Boost” and 12 dB. of "Cut".
Hooking It All Up The EQ 200 should be connected through the "Tape Monitor Loop” of you receiver, integrated amplifier, or amplifier. Since the BQ 200 replaces the tape deck, remember to activate the "Tape Monitor” switch on your receiver, integrated amplifier, or amplifier as you would when playing your tape deck.
. Audiometer EQ 200 Specifications Frequency Response Harmonic Distortion 10Hz -kHz £.03% of nominal output ! Signal to Noise Ratio 95dB Input Impedance 100k Ohms Output Impedance 600 Ohms Load Impedance 10 k Ohms o more Inputs Audio Video, Tape 1, Tape 2 Q Outputs Main , Tape 1,Tape 120 Hz, 250 Hz, 500 Hz, 1 kHz, 2 kHz, 4 kiz, 8 kibitz, 16 kHz or-124dB Control Center Points Control Range Dimensions 16 172" {W) x 3 172" (H) x 11 1/4" (D} Weight {without packaging) 8 lbs.