Owner's Manual

14
Connectors and control units
13
Speaker Output
Speaker outputs for connecting subwoofers.
14
Power & Protect LED
This LED indicates the operating mode of the
amplier.
15
Fuse
Input fuses – 3 x 40 Ampere.
16
+12 V
Connector for the +12 V power cable of the
positive terminal of the battery.
17
REM
Connector for the remote cable.
18
GND
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
1
Line Input
RCA inputs for connecting lowlevel line
signals.
2
Highlevel Input
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
lowlevel line outputs.
.
3
Gain
Control for adjusting the input sensitivity of
the lowlevel Line and Highlevel Inputs.
4
Phase
Control for adjusting the phase from 0° to
180°.
5
TwinPower Link switch
Switch for operating two M ONE X ampliers
in bridge mode.
6
Mono RCA/Cinch In- / Output
Mono RCA/Cinch signal in- or output for
bridge mode operation in TwinPower Link
mode.
7
Bass Boost Gain
Control for adjusting the bass boost from 0 to
12 dB.
8
Bass Boost Q-Factor
Control for adjusting the Q factor (bandwidth)
of the Bass Boost
9
Bass Boost Frequency
Control for adjusting the center frequency of
the Bass Boost from 30 to 80 Hz.
10
Subsonic
Control for adjusting the subsonic lter from
10 to 50 Hz.
11
Lowpass
Control for adjusting the lowpass lter from
50 to 250 Hz.
12
Remote
Input for connecting the included cable
remote control for volume adjustment.
1 2 5
7
8
9 10 11 12
3 4 6
14
18
16
17
13
15