Owner's Manual
22
Example congurations for TwinPower Link operation
Master Slave
Amplier connection in TwinPower Link operation
Speaker connection in TwinPower Link operation
Master Slave
One subwoofer with one voice coil
(single voice coil)
RMS output power ≤ 1% THD+N:
1 x 4 Ohms: 1,400 Watts
1 x 2 Ohms: 2,060 Watts
Note: The negative terminals of both ampliers have to
be connected by using a speaker wire. The size should
be similar to the speaker wires which are used for the
subwoofer connection.
Signal from the radio
(RCA/Cinch or highlevel)
RCA/Chinch cable
Switch setting:
Master
Switch setting:
Slave
Master Slave
One subwoofer with dual voice coil
in mono operation
(dual voice coil)
RMS output power ≤ 1% THD+N:
2 x 4 Ohms: 800 Watts
2 x 2 Ohms: 1,400 Watts
2 x 1 Ohm: 2,060 Watts
Note: The negative terminals of both ampliers have to
be connected by using a speaker wire.
The negative terminal of the rst voice coil has to be con-
nected to the positive terminal of the second voice coil.
The gauge of the wires should be similar to the speaker
wires which are used for the subwoofer connection.