User Manual

21
AmplierconnectioninTwinPowerLinkoperation
One subwoofer with dual voice coil in mono
operation (dual voice coil)
RMS output power ≤ 1% THD+N:
2 x 4 Ohms: 1,000 Watts
2 x 2 Ohms: 1,760 Watts
2 x 1 Ohm: 3,000 Watts
Note: The negative terminals of both ampliers have to
be connected by using a speaker wire.
The negative terminal of the rst voice coil has to be con-
nected to the positive terminal of the second voice coil.
The gauge of the wires should be similar to the speaker
wires which are used for the subwoofer connection.
Speaker connection in TwinPower Link operation
One subwoofer with one voice coil
(single voice coil)
RMS output power ≤ 1% THD+N:
1 x 4 Ohms: 1,760 Watts
1 x 2 Ohms: 3,000Watts
Note: The negative terminals of both ampliers have to
be connected by using a speaker wire. The size should
be similar to the speaker wires which are used for the
subwoofer connection.
Important: The lter settings for the high- and lowpass must be adjusted in an upstream DSP or DSP am-
plier. The GAIN setting is assumed by the master amplier.
* It is su󰀩cient to connect only one input channel (see page 22, item 1).
Master Slave
RCA / Cinch signal
from the radio
RCA / Cinch cable
Switch setting:
Master
Switch setting:
Slave
Master Slave
ExamplecongurationsforTwinPowerLinkoperation
Master Slave