Manual

28
CongurationnotesfortheDSPsoundeffects
The MATCH UP 7DSP offers unique DSP sound
effects like “Augmented Bass Processing”,
“ StageXpander”, “RealCenter” and many more. In
order to enjoy all DSP sound effects, specic set-
tings have to be made in the hardware and software
conguration.
Notes for Center Processing with its functions
RealCenter and ClarityXpander
If you want to use the RealCenter and ClarityXpander
function for a center speaker follow the subsequent
steps:
1. You need at least one left and one right analog or
digital input signal.
2. Open the IO menu of the DSP PC-Tool. Route the
left and the right analog or digital input signal (no
sum signal) to the output channels A and B (see
example in the following image). It does not mat-
ter, if the output channels are dened as front,
rear or center channel.
Note: You will achieve the best performance if
the input signal is a fullrange signal.
3. Generate a summation signal from the same two
input signals and route this to the output chan-
nel G. This channel should be dened as “Center
Full”.
4. Repeat steps two and three for all routing matri-
ces that are used.
5. Now switch to the FX menu and activate the de-
sired sound effect by placing a tick.
Note: The Center Processing effects only the out-
put channel G.
Notes for StageXpander and ClarityXpander
function
Normally, the settings of the StageXpander and
Front ClarityXpander only affect the output chan-
nels A and B. If you want to drive a fully active
2-way front system, it is necessary that these sound
features affect all four output channels A to D.
Therefore, you have to activate the routing in the
FX menu under “Front Processing” by activating the
“Link to C+D” function.
Notes for Augmented Bass Processing with
its functions Dynamic Bass Enhancement and
SubXpander
There are as well some adjustments necessary if
the Augmented Bass Processing and its sound ef-
fects shall be used.
1. You need at least one left and one right analog or
digital input signal.
Note: If you use the analog input then you
achieve the best performance if all four input
signals are used.
2. Open the IO menu in the DSP PC-Tool. Generate
a summation signal from all left and right analog
or digital input signals and route this to output
channel E and output channel F.
3. Repeat the routing for all routing matrices used.
4. Now switch to the FX menu and activate the de-
sired sound effect by placing a tick.
Note: The Augmented Bass Processing effects only
the output channels E and F.