Installation guide

19
Overhead Dome Lights
The Dome Lights integrated into the unit are controlled by a three position slide switch. Sliding the switch to the ON position will turn the light ON. The OFF
position will prevent the lights from turning ON with the vehicle interior lighting. The AUTO position will allow the lights to turn ON and OFF with the vehicle
interior lighting.
Refer to the installation guide for wire connections. Do not leave the vehicle unattended with the dome light switch in the ON position, as this could discharge
the battery.
Infrared Remote Sensors
The unit incorporates two infrared remote sensors which relay signals from the remote control to allow the unit to be controlled simply by pointing its remote
control at the remote sensor. The infrared sensor can relay signals from most manufacturer’s remote control to its respective component connected to the AV
input, in this case, you must use the remote control supplied with the component.
Optional IR Headphones
Optional IR (infrared) headphones are available. Part numbers:
• IR1C
• IR1CFF
• IR2CFF*
* Required if the unit is set to IRT-B setting.