~"'RESTIGE ,_: . •ria~::'::':~. try Model APS-995C Owner's Manual AUDIOVOX 4 Button Remote Start Security System With Plug-In Shock Sensor & Starter Disable IMPORTANT I In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry. It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure.
• Protected Push Button ValeUOverride Switch • 7-Function LED-Arm f Disarm f Zone 1 f Zone 2 f Zone 31 Valet I Arming • Intrusion Alert With Memory • Instant Siren Activation • Starter Disable Output • Additional Engine Immobilizer Output, (Optional Relay Required) • True Last Door Arming (Hardwire Only) • Defective Zone By-Pass • Defective Zone Chirp Confirmation (Unit Chirps To Report Zone Cleared) • 6 Tone Mini Siren • Car Horn Output For Additional Alarm Response (Improved Timing To Minimize • • • •
known as a code grabber, which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Your Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then fe-transmits your signal, the alarm system will not respond.
o Siren will not sound. If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar. Simply close the opened entry point to provide full protection o Doors Lock - Optional NOTE: If the optional Headlamp illumination feature has been added, and has been selected for operation when arming, as an added convenience, the system will turn on the headlights when the system is armed. The LCD Remote has the following response: ARMING THE SYSTEM - PASSIVE (AUTOMATIC) 1.
Ii'1 Any mild impact to the vehicle's glass will cause the alarm to sound a short senes of warning tones. o Any strong impact to the vehicle's glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as well for the full 30 second alarm cycle.
The LED will start flashing rapidly, indicating that the system is fe-arming automatically. Open any door to suspend the automatic arming. Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. 10 Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence.
When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational. In addition, the parking lights will flash to indicate locking and unlocking. To use the valet mode, the system must first be disarmed either by using your keychain transmit~ ter or by activating your personalized manual override code. 1. Enter the vehicle and turn the ignition key to the on position. 2.
If the new code was accepted, the unit wiH report back the newly entered code, by flashing the LED, first indicating the 10ths digit. pause and then the units digit. The unit will report the new code three times with a one second pause between each code, then the system will begin arming, If the LED flash pattern reports the previously stored code, the new code was not entered correctly. Please repeat steps 1 through 7 above considering the following.
1 Enter the vehicle and turn the ignition switch to the on position. NOTE: The siren wi!1 sound. 2. Within 5 seconds, press and release the pushbutton switch 1 time. 3. Within 5 seconds, turn the ignition switch off then on. 4. Within 5 seconds, press and release the pushbutton switch 1 time. 5. Tum the ignition switch off then on and start the vehicle. NOTE: If you have changed the programmed override code then substitute your new code tenths for step 2 above, and units for step 5 above.
R F SHOCK SENSOR MODE SELECTION The way in which your alarm system reacts to threatening vibrations, created by attempts to enter the vehicle by breaking a window, is adjustable by the transmitter immediately after arming. There are 4 modes of operation that can be selected by the operator: 1. Normal Operation (default mode) In this mode, any strong vibrations will cause the siren to sound (full detect) for 30 seconds.
3. Within 10 seconds, move the control switch off, on, off, on (2 switch CYCles/ to select a 2 hour start timer. After 10 seconds expire, the parking lights wil flash and the siren will chirp 2 times confirming that the two hour start cycle is set. Or, within 10 seconds move the control switch off, on, off, on, off, on, off, on (4 switch cycles) to select a 4 hour start timer. The parking lights will flash and the siren will chirp 4 times confirming that the 4 hour start timer is set.
the only means to keep the engine and engine fluids warm is to periodically start the engine. WARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged. TO BEGIN THE AUTOMATIC START UPTIMER 1. Turn the ignition key on then off. 2. Within 10 seconds, activate the RF start command two times.
o Remote Electric Trunk Release Remote Car Starter o Remote Window Closure o Remote Garage Door Interface o NOTE: In addition there may be a second optional feature connected to your system that when the same transmitter button is pressed and released 2 times within 3 seconds (double pressed), the second optional feature will activate.
ADDITIONAL REMOTE FUNCTION (CHANNEL 6) Channel 6 is an alternate output that can be controlled by the unlock button of the transmitter, or by and independent button or combination of buttons. For your vehicle this output is: Controlled By: 0 Trunk/Key Button 0 Option Button 0 Lock + Unlock Buttons 0 Lock + Trunk/Key Buttons 0 Lock & Option Buttons 0 Unlock + Trunk/Key Buttons o Unlock & Option Buttons 0 Trunk/Key & Option Buttons Other Transmitter button configurations are also available.
TRANSCEIVER ICONS AND THEIR INDICATIONS When Disarmed, Press the Arm/Lock button to Lock and Arm the System. The Lock Icon is displayed on the LCD panel & the parking lights flash once. When Armed, Press the Disarm/Unlock button to Unlock and Disarm the System. The Unlock Icon is displayed on the LCD panel & the parking lights flash twice. When the Key Icon Button Has Been Operated for 3 seconds the trunk open icon will flash on the LED Screen.
The following trigger patterns will be displayed. Triggered and the entry attempt was made to one of the vehicle doors. Triggered and entry attempt was made to the vehicles hood or trunk. Triggered and entry attempt was made to the vehicles glass, or the vehicle has been hit or bumped hard enough to cause a response from the vibration detector.
ADDITIONAL REMOTE FEATURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display, toggle ~_A~$>=:=::::\ the transmitter from beep tones to vibrate mode, initiate daily start timer, and temperature start. Selection of these and other features are shown below: NOTE: Transmitter must be within operating range of the vehicle, approximately 1000 ft. Check Vehicle Status: Press the lock+key+option buttons simultaneously for 1 second.
II, you require more Trequem sIarung p,ease rerer 10 auw sIarr up lImer mooe shown earlier In this gUide. NOTE: To insure accurate 24 Hour Start up, it is advisable to reset the start time periodically as time may drift slightly each day. Page Call Out: From within the vehicle, if the valet push button is pressed for three seconds, the alarm unit in the vehicle will transmit to the LCD remote and a beep tone will be heard on the hand held transmitter indicating that someone is calling you to the vehicle.
TRANSMITTER FUNCTION BUTTON r---.~",E",LECTI~ "---1C::---"" TIM~DE HRS,T ® ~ I ALAR~C ON 'OFF I .OWN I® I® I® I® ® ® I ~~b~~u ~""";·."0IDY,-,"'-'S.""""C·;··2' 90 MIN PARKING COUNT DOWN TIMER 120 MIN PARKING COUNT DOWN TIMER PARKING COUNT DOWN TIMER OFF MODE BACKUGHT DISPLAY FOR 10 SECONDS TONENIBRATE ::18:88 2 BEEP TONES 2X ~18:88 3X I ~18:88 5X I' ON/OFF ax !. ax. 18:88 18:88 8 7X. ® 9 x • ON/OFF ® 10X.
APS995C SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING REARMING SLOW FLASHING OFF ON SOLID 3 FLASH ... PAUSE 2 FLASH ... PAUSE 1 FLASH ... PAUSE = = = = = = = PASSIVE ARMING/ACTIVE ARMED DISARMED VALET MODE INTRUSION ZONE 3 INTRUSION ZONE 2 INTRUSION ZONE 1 SIREN CHIRP INDICATORS 1 CHIRP' ARM 2 CHIRPS' DISARM 3 CHIRPS ARM !DOOR OPENED 4 CHIRPS DISARM /INTRUSION * These chirps are optional, and can be de - activated.
