Owner`s manual
R F SHOCK SENSOR MODE SELECTION
The
way
in
which
your
alarm
system
reacts
to
threatening
vibrations,
created
by
attempts
to
enter
the
vehicle
by
breaking
a
window,
is
adjustable
by
the
transmitter
immediately after arming. There are 4 modes
of
operation that can be selected
by the operator:
1.
Normal Operation (default mode)
In
this mode, any strong vibrations will cause the siren
to
sound (full
detect) for 30 seconds.
Any
lesser
vibration
will
cause
the
siren
to
emit
about
6 short warn
away
chirps, (pre-detect).
2.
Stage 1 (Omit pre-detect)
In
this
mode,
the
warn
away
chirps
created
by
the
lesser
vibration
will
be
deleted.
If
strong
vibration
occurs,
the
siren
will
sound.
3.
Stage 2 (Omit pre & full detect)
In this mode, both the pre-detect stage and
the
full trigger stage
of
the
sensor
are
defeated.
The
unit
will
not
react
to
vibration
of
any
magnitude.
NOTE: Shock Sensor Icon Is Displayed On The LCD Panel.
4.
Stage 3 (City Mode)
In this mode, the pre-detect chirps will change from six pre-warning tones to
a
full
10
seconds
of
warning
chIrps.
The full detect trigger duration will be reduced from 30 seconds to 15 seconds.
NOTE:
Setting
the
stage
of
the
shock
sensor
will
be
effective
for
one
arming
cycle
only.
Once
the
system
has
been
disarmed,
the
very
next
arming
cycle
will
cause
the
sensor
to
default
to
the
normal
operation
stage.
To
change
or
adjust
the
shock
sensor,
press
and
release
the
ARM
button
of
you
keychain
transmitter.
1.
Within 2 seconds
of
arming,
fress
and release
the
ARM
button 1 time,
to
defeat the pre-detect stage a the shock sensor. (The lights will flash and the
siren
will
chirp
once.)
2.
Within 2 seconds of step
1,
press and release
the
ARM
button 2 times, to
defeat
the
pre and full detect stages
of
the shock sensor. (The lights will
flash and the siren will chirp twice.)
3.
Within 2 seconds of step
1,
press and release the
ARM
button 3 times to
enter the "City Mode"
of
operation. (The lights will flash and the siren will chirp
three times.)
SAFETY (Red
Handled)
CONTROL SWITCH
The
control
switch
allows
you
to
temporarily
disable
the
remote
starting
function
of your APS-995C.
To
disable the unit, move
the
red handled control switch to the
off
position.
The
control
switch
also
allows
you
to
select
between
2
hour
start
up
and
4
hour
start
up
when using
the
automatic start
up
timer mode. The factory preset start
up
time
for
this
mode
is
every
4
hours.
To
select
between
2
or
4
hour
start-up
timer:
1.
Begin
with
the
control
switch
in
the
on
position.
2.
Turn
the
ignition
switch
on
then
off.
Page10
128-6425
10
of
20