Owner`s manual

ADDITIONAL REMOTE FEATURES:
The
two
way
remote
control
unit
allows
you
to
access
status
information
from
the vehicle, check temperature, light the display, toggle
~_A~$>=:=::::\
the
transmitter
from
beep
tones
to
vibrate
mode,
initiate
daily
start
timer,
and
temperature
start.
Selection
of
these
and
other
features
are
shown
below:
Check Vehicle Status:
NOTE:
Transmitter
must
be
within
operating
range
of
the vehicle, approximately 1000
ft.
Press
the
lock+key+option
buttons
simultaneously
for
1
second.
alarm will display the systems current status.
The
vehicle's
Check Temperature:
Press
the
optlon+key
buttons
simultaneously
for
1
second.
The
vehicle's
alarm
will
display
the
temperature.
Temperature
is
read
from
the
alarm's
module
located below the dashboard. This reading may
be
higher than actual ambient
temperature
due
to
the
greenhouse
and
is
relabve
only
to
the
inside
vehicle
temperature.
Temperature
Start
Mode:
To
toggle this feature
on
or off, from the armed mode, press the Option & Unlock
Buttons
simultaneously,
the
temperature
icon
appear
on,
or disappear
from
the
display, and the transmitter will emit a tone.
NOTE:
This
feature
must
be
active
in
the
feature
selection
menu
of
your
system.
Check
with
your
installing
dealer
to
insure
this
feature
is
set
to
the
on
position.
Light The Display:
Press and release the "F" (Function) button one time. The display will illumi-
nate for 1 0 seconds.
Vibrate
Or
Tones:
Press
the
"F"+Unlock
buttons
simultaneously
for
1
second.
The
transmitter
will
vibrate
if
vibrate
is
on
or
beep
if
tones
are
turned
on.
Pressing
this
button
combination
again
will
toggle
this
feature
on
or
off.
Daily Start Timer:
Press
the
option+lock
buttons
simultaneously
for
1
second.
The
transmitter
will
beep and display the 24hr timer. The vehicle will start automatically when the
time
set
is
reaclled. (see
chart
for
time
settings).
Pressing
this
button
combina-
tion
a
second
time
Will
toggle
this
feature
off.
Note
the
transmitter
must
be
within
range
of
the
vehicle
10
set
this
feature
and
within
range
to
cause
the
vehicle to start at the preset time. The unit will start at the prescribed time once
only.
This
function
must
be
selected
each
time
you
want
the
vehicle
to
start.
To
aclivate this function,
(a)
Turn the ignition switcn off. (b) Within
10
seconds of
step (a), depress and
hold the
braKe
pedal, while pressing the key icon
transmitter
button
2
times.
Ic)
the
unit
will
emit
2
chirps,
the
transmitter
will
beep
and
the
start
timer
icon
on
he
display
will
remain
on.
Note
this
feature
must
be
pre-selected
at
time
of
installation
and
will
require
resetting
each
day.
Also
the
unit
will
start
once
and
run
for
the
prescribed
time.
128ยท6425
17
of
20