Owner`s manual
known as a code grabber, which will receive and store the signal from your
keychain transmitter and re-transmit at a later time to disarm your system.
Your Keeloq Code Hopping transmitters will change their signal every time the
button is pressed,
so
when a thief grabs then fe-transmits your signal, the alarm
system will not respond.
If your transmitter button is pressed more than fifty times while it is out
of
range of
the vehicle (children playing with your keys), the transmitter will not operate when
you return to the vehicle, and will need to be
re-aligned
to
the receiver.
To
do this,
simply press button
1,
(lock), two times within a one second time period. The
system
will
now respond
to
that transmitter each time a button
is
pressed.
NOTE:
This system is custom configurable and can be set up to operate with a
number
of
options controlled from any transmitter button
or
button com-
bination. For reference, we
will describe operation assuming that your
system
is
programmed for separate lock and unlock buttons. Also refer-
ence
will be made to the icons as shown on the buttons below.
NOTE: The
LCD based remote will be explained
in
detail further
in
this manual
See
"System Status" described later
in
this manual. Consult your instal-
lation center
if
your system has been configured differently.
NOTE:
Your system has the option
of
using a siren, the vehicle horn,
or
both for
the sounding device. Where the siren is referenced below, the horn
or
both may
in
fact chirp,
or
beep.
ARMING THE SYSTEM -ACTIVE
1.
Turn off the engine, exit the vehicle, and close all doors, hood lid and trunk lid.
2.
Press and release Lock/Arm button on the keychain transmitter.
0'1
The dash mounted LED begins to ftash slowly.
0'1
Parking Lights flash one time.
o Siren sounds one chirp.
If
the siren sounds 3 chirps, then you have left a door, trunk or
hood lid ajar.
Simply close the opened entry point to provide full
protection.
If
the siren did not sound when arming, then the
chirps have been turned off and you should refer
to
the section
titled
"ELIMINATING
THE
ARM / DISARM CHIRPS"
in
this
manual.
o Doors Lock - Optional
NOTE:
If the optional Headlamp illumination feature has been added, and has
been selected for operation when arming, as an added convenience, the
system will turn
on
the headlights when the system is armed.
SILENT ARMING - ACTIVE (Must be activated during programming)
1.
Turn off the engine, exit the vehicle and close all doors, hood lid and trunk lid.
2.
Press
and
hold
the
Lock/Arm button on
the
keychain
transmitter
for
2
seconds.
0'1
The dash mounted LED begins to ftash slowly.
0'1
Parking Lights flash one time.
Page3
128-6425
3
of
20