Owner`s manual
Ii'1
Any
mild
impact
to
the
vehicle's
glass
will
cause
the
alarm
to
sound
a
short
senes
of
warning
tones.
o
Any
strong
impact
to
the
vehicle's
glass
will
cause
the
alarm
to
trigger
for
the full 30 second alarm cycle.
NOTE:
If
the
optional
interior
illumination
circuit
was
installed,
the
interior
light
will flash
as
well for the full 30 second alarm cycle.
DISARMING
THE
SYSTEM
NOTE:
If
the optional 2 step door unlock circuit
is
installed, when the unlock
transmitter
button
is
activated,
the
drivers
door
only
will
unlock,
pressing
the
unlock
button
a
second
time
will
cause
all
doors
to
unlock.
NOTE: If your transmitter has been configured with single button Lock/Unlock, to
activate the
all
door
unlock
feature operate
the
Lock/Unlock
button
a
second
time
within
3
seconds
of
the
first
unlock
command.
1.
As
you
ap~roach
the vehicle, press and release the Unlock/Disarm button
on
the
keycham
transmitter.
1<1
The dash mounted LED turns off.
The
LED
will start flashing rapidly, indicating that the system
is
re-arming
automatically.
Open
any
door
to
suspend
the
auto-
matic
arming.
1<1
Parking Lights flash two times.
If
the parking lights flashed three times, then the alarm was
triggered
in
your
absence.
Before
turning
the
key
on, examine
the LED to identify which zone was triggered.
o
Siren
sounds
two
chirps.
If
the
siren
sounds
4
chirps,
then
the
alarm
was
triggered
in
your
absence.
Before
turning
the
key
on,
examine
the
LED
and
refer to the INTRUSION WARNING SIGNALS section of this
manual
to
identify
which
zone
was
triggered.
If the siren did not sound when disarming, then the chirps have
been turned off
and
you
should refer
to
the section titled
"ELIMINATING THE ARM I DISARM CHIRPS"
in
this manual.
o Doors Unlock - Optional
o 2 Step Doors Unlock - Optional
NOTE:
If
the optional Headlamp illumination feature has been added and has
been
selected for operation
when
disarming, as
an
added convenience,
the system
will
turn
on
the
headlights
when
the
system
is
disarmed.
SILENT DISARMING (Must
be
activated during programming)
Note:
If
the optional 2 step door unlock circuit is installed, when the unlock
transmitter
button
is
activated,
the
drivers
door
only
will
unlock,
pressing
the
unlock
button
a
second
time
will
cause
all
doors
to
unlock.
NOTE: If
your
transmitter
has
been
configured
with
single
button
Lock/Unlock
as
shown, to activate the
all
door unlock feature operate the Lock/Unlock button
a
second
time
within
3
seconds
of
the
first
unlock
command.
1.
Press
and
hold
button
the
Unlock/Disarm
button
on
the
keychain
transmitter
for
2 seconds.
1<1
Red dash
me,
nfocl
LED
tu
;~
Off'=======;;;;;;;;;;!1
"
128ยท6425
5
of
20