Owner`s manual
When the system is in valet mode, all alarm functions are bypassed, however the
remote panic feature and remote door locks
will remain operational.
In
addition,
the parking
lights will flash to indicate locking and unlocking.
To
use the valet
mode,
the
system must first be disarmed either
by
using your keychain
transmit~
ter
or
by activating your personalized manual override code.
1.
Enter the vehicle and turn the ignition key
to
the on position.
2.
Press and hold
the
valet pushbutton switch until the dash mounted
LED turns
on
solid. The system will remain in the valet mode.
3.
To
return to normal operation, press and release the pushbutton switch
any time the ignition is on.
NOTE:
Always
remember
to
return
the
system
to
normal
operation.
This
will
ensure
that the vehicle remains protected at all times.
MANUALLY
OVERRIDING
YOUR
SYSTEM:
USING
THE
VALET SWITCH MANUAL OVERRIDE
Your Security System can be disanned without the use of the keychain transmitter. This
is
necessary, since you will need the ability to operate your vehicle if the transmitter
is
lost or
its battery fails. If your system has been selected for Valet Swoch manual override as
indicated
on
the last page
of
this manual, to bypass the
alanm
system;
1.
Open the vehicle door. The alarm will sound.
2. Turn the ignition key to
the
on position.
3. Within 5 seconds, press and release the valet pushbutton switch.
The
alarm system will stop sounding and enter the (bypass) mode. You can now
start and operate the vehicle normally.
Typically this override mode is used
only if the transmitter has become inopera-
tive.
Programming Your Custom Override Code:
Unlike override switches easily found, and defeated, this security system allows the
consumer to
program
a personal override code, offering a higher !evel of security.
To
take
advantage of this option, programmable feature
#
10
must
be
selected for the Custom
Code
Option. Consu!t your installation center for programming detai!s. The system
comes
from
the factory with a pre-programmed override code of
11.
To
change this
default override code, do the following:
1.
Disarm
the
system bv use
of
the transmitter,
or
by use
of
the
emergency
override sequence.
lurn
the ignition switch to the on position.
2.
Within 10 seconds, press and release
the
valet/override switch, 3 times.
3. Within 10 seconds turn the ignition switch off, on, off, on, off, on.
(The siren
or
hom will beep and the lights will flash one time.)
4. Within
10
seconds, begin to enter
your
chosen 10ths digit by pressing and
releasing the pushbutton switch from 1 up
to
9 times.
5. Within 10 seconds
of
the last entered 10ths digit, turn the ignition switch
off
then on.
6.
Within 10 seconds, begin
to
enter your chosen units digit
by
pressing and
releasing the pushbutton switch from 1 up to 9 times.
7.
Finish by turning
the
ignition switch to
the
off
position.
Pagel
128-6425
7
of
20