Owner`s manual

If
the
new
code
was
accepted, the
unit
wiH
report
back
the
newly
entered
code,
by
flashing the LED, first indicating the 10ths digit. pause and then the units digit.
The
unit
will
report
the
new
code
three
times
with a
one
second
pause
between
each code, then the system will begin arming, If the LED flash pattern reports the
previously stored code, the new code was not entered
correctly. Please repeat
steps
1
through
7
above
considering
the
following.
N01E: Acceptable digits 10ths or units are 1 through 9, The
unit
will not
recognize
a 0 (Zero),
or
no
digit
entered
in
any
place, units
or
tenths.
NOTE:
If
15
seconds
of
inactivity expire or
if
the ignition switch is turned off for
more
then
5
seconds
during
any
of
the
above steps,
the
unit
wi!! revert
back to the last successfully stored code,
Custom
Code
Programming
Example:
To
Change
the
code
from the
factory
pre-assigned
code
of
11
to
"52"
you
would
do
the following:
1.
Disarm
the
system
by
use
of
the
transmitter
or
by
use
of
the
emergency
override
sequence.
2.
Tum
the
ignition switch
to
the
on position.
3.
Within 10 seconds, press and release
the
valet/override switch, 3 times.
4. Within
10
seconds
turn
the
ignition
switch
off, on, off, on, off, on.
(The siren or horn will beep and the lights will flash one time,)
5.
Within
10
seconds,
begin to
press
and
release
the
pushbutton
switch
to set
the tenths
digit
(As per the example, press and release 5 times to set the tenths digit to
5)
6,
Within 10 seconds of the last press of the pushbutton, turn the ignition switch
off then
on,
7.
Within
10
seconds,
begin
to
press
and release
the
pushbutton
switch
to
set
the units
digit
(As per the example, press and release 2 times to set the units digit to 2),
8.
Turn
the
ignition switch
to
the
off
position.
Immediately
observe
the
LED
flash
pattern,
You
wi!!
note
the
LED
flashing five times, pause,
and
then
flash
two
times, pause.
This pattern will be repeated three times indicating the new code (52) has been
accepted
and stored
in
memory.
N01E: If after step
7,
the LED flashes a code other than what was just entered,
this indicates
that
the
code has
not
been changed. You
wi!!
have
to
repeat
steps
1
through
7
above
being certain
to
note
the
following:
Acceptable
digits 10ths
or
units are 1
through
9.
The
unit
wi!!
not
recognize
a 0
{Zero},
or
no
digit
entered in
any
place, units
or
tenths.
NOTE:
If
15
seconds
of
inactivity expire,
or
if
the
ignition switch is
tumed
off
for
more
then
5
seconds
during
any
of
the
above
steps,
the
unit
will
revert
back
to
the
last successful!y stored code.
MANUALLY
OVERRIDING
YOUR
SYSTEM:
USING
THE
CUSTOM
CODE
OVERRIDE
Assuming
the
override
code
programmed
has
not
been changed, and
the
default
override
code
of
11
is
in
the
system's
memory.
PageS
128-6425
8
of
20