Owner`s manual

1 < Enter the vehicle and turn the ignition switch to the on position.
NOTE:
The
siren
wi!1
sound.
2.
Within 5 seconds, press and release the pushbutton switch 1 time.
3.
Within 5 seconds, turn the ignition switch
off
then on.
4.
Within 5 seconds, press and release the pushbutton switch 1 time.
5.
Tum
the ignition switch off then on and start the vehicle.
NOTE:
If you have changed the programmed override code then substitute your
new code tenths for step 2 above, and units for step 5 above.
ELIMINATING
THE
NORMAL
ARM
{DISARM
CHIRPS
As
explained
earlier
in
the
manual,
you
can
eliminate
the
chirps
selectively
any
time you arm
or
disarm the system simply by holding the ARM
or
DISARM button
for
two
seconds.
If
you
find
the
normal
arming
and
disarming
chirps
annoying,
they can be turned off permanently, eliminating the need to hold the ARM I
DIS-
ARM button for 2 seconds.
To
do this,
1.
Tum
the ignition key on then off.
2.
Within
10
seconds,
press
and
release
valet
switch
three
times.
3.
If
the
chirps
were
on
before
you
started,
then
you
will
hear
two
chirps
indicat-
ing
they
have
been
turned
off.
If
the
chirps
were
off
before
you
started,
then
you
will
hear
one
chirp
indicating
they have been turned on.
NOTE:
Whenever the
chirps
are bypassed, the 4-chirp intrusion indicator
and
3
chirp
defective
zone
indicator
will
always
operate.
Since
these
are
important warnings to you that something has happened, they cannot be
eliminated.
NOTE:
Your
s„stemmust
be
programmed
by
the installation center
to
en-
able
thIS
feature.
REMOTE
PANIC
OPERATION
The
Lock
or
Unlock
button
on
your
keychain
transmitter
also
functions
as
a
panic
switch
for
use
in
emergency
situations.
To
use
remote
panic,
1.
Press and hold the Lock
or
Unlock button on the keychain transmitter for 3
or
more
seconds.
The
alarm
will
immediately
sound.
2.
To
stop the alarm, press and hold the Lock
or
Unlock button on the transmitter
again
for
3
seconds.
If
the
button
is
not
pressed,
the
alarm
will
automatically
stop
after
30
seconds.
Also
if
any
transmitter
button
other
than
the
Lock
or
Unlock
button
is
pressed
and
released,
the
Panic
mode
will
be
turned
off
immediately.
The
normal
function
of
this
transmitter
button
will
be
suspended
during
the
Panic
sounding
period.
3.
During
the
panic
mode,
the
Lock
and
Unlock
buttons
can
be
used
to
lock
and
unlock
the
doors,
(if
the
option
is
installed),
however
once
the
unlock/disarm
button
is
pressed,
the
vehicle's
starter
inhibit
device,
(where
installed)
will
be
disabled allowing the vehicle to start.
NOTE:
While
in
the Panic
mode,
pressing
and
releasing the
Lock
or
Un-
lock buttons will, if the option is installed, lock and unlock the doors respectively.
While
in
the
panic
mode,
anytime
the
Unlock
button
is
pressed,
the
panic
feature
will
continue
for
the
allotted
30
seconds,
however,
the
security
system
will
be
disarmed
allowing
the
vehicle
to
start.
Page9
128-6425
9
of
20