Wireless Transmitter and Receiver Model:ACA300 Installation Manual Features: • Operating frequency: 2.4GHz.
Warnings The product is intended to assist in safe driving and to allow the driver to have a broader rearview while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to the country and their local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle.
Table of Contents Warnings 1 Table of contents 2 Product description 2 Packing list 2 Transmitter/Receiver installation 3 Specifications 4 Troubleshooting 5 Product Description The wireless transmitter and receiver have been developed to convert a hard wire camera/monitor system to a wireless operation. The following information contained in the installation manual is for camera backup systems. Note: this product can be used on any Camera/Monitor system. Packing List 1.
Transmitter/Receiver Installation The transmitter and the receiver must be installed in the vehicle’s trunk or interior. The transmitter and receiver are not weather proof and must be located in a dry location Tap/Run Connection Wiring the transmitter to the vehicle reverse lamp. Using the tap connectors supplied. i. Place the unstripped positive lead wire on the run channel ii. Insert the unstripped red power wire completely iii.
Wiring the receiver to the vehicle. Choose a source that only has power when the vehicle is running. Connect as shown Using the tap connectors supplied. i. Place the unstripped ignition source wire on the run channel ii. Place the unstripped red power wire completely iii. Fold the tap connector back over the wires and make the connection by crimping the u-contact down flush with the plastic insulator. iv. Close the top hinged cover until latched. b. Black wire- Chassis/Ground. Using ground ring supplied, i.
Troubleshooting Symptoms The Monitor is not on after the vehicle is started and vehicle is in reverse? No video signal appears while reversing the vehicle? Video image is not sharp enough? Solutions Check the monitor and the receiver wiring and connection. Check the rearview Camera and the Transmitter wiring connection. Clean the lens of the camera. © 2007 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.