Installation Manual

Transmitter/Receiver Installation

The transmitter and the receiver must be installed in the vehicle’s trunk or

interior. The transmitter and receiver are not weather proof and must be

located in a dry location

/Run Connection

a) Wiring the transmitter to the vehicle reverse lamp. Using the

tap connectors supplied.

i. Place the unstripped positive lead wire on the run channel

ii. Insert the unstripped red power wire completely

iii. Fold the tap connector back over the wires and make the

connection by crimping the u-contact down flush with the

plastic insulator.

iv. Close the top hinged cover until latched.

b) Black wire- Chassis/Ground. Using. Using the tap connectors

supplied.

i. Place the unstripped ground lead wire on the run channel

ii. Insert the unstripped black ground power wire completely

iii. Fold the tap connector back over the wires and make the

connection by crimping the u-contact down flush with the

plastic insulator.

iv. Close the top hinged cover until latched.

2. Wiring the transmitter to the camera.

a) Connect the transmitters RCA connector to the Cameras RCA

connector.