Installation Manual

a. Wiring the receiver to the vehicle. Choose a source that only

has power when the vehicle is running. Connect as shown

Using the tap connectors supplied.

i. Place the unstripped ignition source wire on the run channel

ii. Place the unstripped red power wire completely

iii. Fold the tap connector back over the wires and make the

connection by crimping the u-contact down flush with the

plastic insulator.

iv. Close the top hinged cover until latched.

b. Black wire- Chassis/Ground. Using ground ring supplied,

i. Place stripped wire (1/4”) inside connector

ii. Crimp the connector using a crimping tool to secure the

wire.

Specifications:

1. Operating voltage: 11.5V-14.5V

2. Operating current:

Transmitter: 70mA

Receiver: 180mA

3. Operating frequency: 2.4GHz

4. Operating temperature: 0-50