3.5” LCD Backup Monitor Model: ACAM350 Installation/User’s Manual Features: • 3.
Warnings This product is intended to assist in safe driving by signaling the driver of obstacles behind the vehicle while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to your local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your vehicle.
TABLE OF CONTENTS Warnings 1 Product description 2 Packing list 3 Installation Instructions 3 Operations 4 Maintenance 5 Troubleshooting 5 Warranty card 7 Product Description This Rearview Mirror/Monitor, when used with a backup camera, is designed to assist the driver by providing a clear and wide image of the area behind the vehicle whenever the vehicle is shifted into reverse. Never rely solely on this product to ensure the area is clear of children and/or obstructions.
Packing List Description Figure 3.
Installation Instructions Mounting the Monitor The monitor with flexible mounting pad and 3M tape mounts on either the vehicle windshield or dashboard. 1. Choose a monitor location in your vehicle that does not block your view for safe driving. 2. Clean the monitor mounting area with the alcohol wipe provided. 3. Remove the protective film from the 3M flexible adhesive mounting pad on the bottom of the monitor and carefully press into place. Note: Once pressed into place, the pad cannot be easily moved.
Wiring the Monitor 1. Wire the Power Cable to the vehicle’s reverse lamp. a) Locate the reverse lamp in the tail light assembly. Using the tap connector supplied, perform the following steps: i. Place the un-stripped positive lead wire on the run channel. ii. Insert the un-stripped red power wire completely. iii. Fold the tap connector back over the wires and make the connection by crimping the u-contact down flush with the plastic insulator. iv. Close the top hinged cover until latched.
Operation The monitor will automatically display the rear observation camera image whenever the vehicle is engaged in reverse. Maintenance Though your Monitor requires little care, you can still maintain its condition and performance following the procedures below. • Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. • Keep liquids away from the display monitor. • To avoid damage, do not place auxiliary devices or other objects on the top of the monitor.
Troubleshooting Symptoms Solutions The ON/OFF signal light is not on after the car is started Ensure that the parallel red and black line from the control box is connected properly. No video signal appears while reversing the car 1. Verify that the LCD Contrast (Brightness) control knob is not set too low 2. Check the rearview Camera lens. 3. Check the rearview Camera wiring and connection. 4. Confirm that the cable from the monitor is connected properly.
8
© 2008 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y.
