6 COMPACT ACC-40 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER MODEL ACC-40 6-DISC CD CHANGER WITH WIRED COMMANDER COMPACT DIGITAL AUDIO INSTALLATION MANUAL
PACKING LIST MAIN UNIT Wired Commander CD Changer FM Modulator 6 COMPACT ACC-40 DIGITAL AUDIO 6 DISC COMPACT DISC CHANGER INSTALLATION PARTS Mounting Bracket Hex Head Bolt with Washer Base (M5 x 12) 2 pcs. 4 pcs. Phillips Head Screw (Large) Phillips Head Screw (Small) 4 pcs. 2 pcs. Mounting Angle Adjustment Tool Screw Hole Cover Labels 1 pc. 1 pc. 5 Meter Din Cable 1 pc. ACCESSORIES 1 CD Magazine Index seal sheet Installation Manual Owner's guide 1 pc. 1 pc. 1 pc. 1 pc.
BEFORE INSTALLING THE UNIT Transport Lock Screws The mechanism in the CD changer is "locked" into place during shipment by the 4 transport screws. Be sure to remove the screws prior to installation. Retain these screws for future use when transporting the unit for service/maintenance. l Caution l After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
INSTALLATION The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip. HORIZONTAL INSTALLATION Set the anti-vibration springs to position "H".
PROCEDURE FOR VERTICAL INSTALLATION Note If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2. 1 Set the anti-vibration springs to position "V". 2 Attach a mounting bracket to each side of the unit, using the hex head bolts with washer base. position "V" 45° V Bracket H Bracket Hex head bolt with washer base 3 Determine the mounting location, and drill four mounting holes.
PROCEDURE FOR 45° ANGLE INSTALLATION Note If the anti-vibration spring position has been changed and verified for 45° angle mounting (as shown on page 3), start with step 2. 1 Set the anti-vibration springs to position "45°". 2 Attach a mounting bracket to each side of the unit, using the 4 hex head bolts with washer base. position "45°" 45 V ° Bracket H Bracket Hex head bolt with washer base 45° 3 Determine the mounting location, and drill four mounting holes.
SYSTEM WIRING AND ADJUSTMENT IMPORTANT - Some import cars use a special dual antenna “Diversity" system. If your car has this type of antenna system, you will find the antenna cable will not fit the socket on the FM modulator. Use of the ACC-40 with “Diversity" systems is not recommended. You may also find some GM cars and others have an antenna plug that is too small to mate with the socket on the FM modulator. If this is found, call Audiovox’s Toll-Free Assistance for a special adaptor.
VEHICLE WIRING IMPORTANT - Some import cars use a special dual antenna “Diversity" system. If your car has this type of antenna system, you will find the antenna cable will not fit the socket on the FM modulator. Use of the ACC-40 with “Diversity" systems is not recommended. You may also find some GM cars and others have an antenna plug that is too small to mate with the socket on the FM modulator. If this is found, call Audiovox’s Toll-Free Assistance for a special adaptor.
