OWNER'S MANU AL MANUAL REL OPEN TUN AF TA TP PTY MTL EON (AUX) MODE TAPE IN CD TUNER VOL ST LOUD PRESET UALIZER MUTE LO/DX SCAN MONO DISP LOUD PAUSE SCAN REPEAT SHUFFLE DISC-DN DISC-UP BAND 1 2 3 4 5 6 AMS SEL DIM ACD-85 AM/FM/MPX RADIO WITH SLIDE-DOWN DETACHABLE FRONT PANEL, COMPACT DISC PLAYER, CD CHANGER CONTROLS, WIRELESS REMOTE CONTROL AND QUARTZ CLOCK
INST ALL AT ION INSTRUC INSTALL ALLA INSTRUCTT IONS INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, trucks, and vans with an existing radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics supply stores and car stereo specialist shops. Always check the kit application before purchasing to make sure the kit works with your vehicle.
UNIVERSAL INSTALLATION USING MOUNTING SLEEVE NUT (5MM) PERFORATED STRAP FASTEN THIS END TO SCREW STUD ON REAR OF CHASSIS EXISTING DASH OPENING FILE EDGES TO FIT IF NECESSARY - DO NOT OVERFILE NOTE: IF DASH IS SOLID, USE REAR SIDE (WITHOUT THE LIP) OF MOUNTING SLEEVE AS A TEMPLATE & CUT OPENING BEND TOP TABS UPWARD SCREW (5MM) INST ALL AT ION INSTRUC INSTALL ALLA INSTRUCTT IONS TOLL-FREE INST ALL AT ION ASSIST A NCE INSTALL ALLA ASSISTA The installation and wiring connections for this unit are so simp
RADIO WIRING RADIO WIRING REFER TO PAGE 5 FOR SPEAKER WIRING ANTENNA AUTOMATIC ANTENNA BLUE IMPORTANT THE BLUE WIRE CAN BE USED TO REMOTELY ACTIVATE AN AUTOMATIC ANTENNA OR AN EXTERNAL AMPLIFIER (SEE ANTENNA OR AMPLIFIER MANUAL) EXISTING ANTENNA CABLE 1.0 AMP. FUSE FUSEBLOCK “RADIO” FUSE +12V ACCESSORY RED SCREW BLACK METAL PART OF DASH (DRILL HOLE IF NECESSARY) CAR BATTERY YELLOW FILTER/FUSE BOX IMPORTANT YELLOW WIRE MUST BE CONNECTED AS SHOWN OR RADIO WILL NOT OPERATE PROPERLY 10 AMP.
WARNING! REFER TO PAGE 4 FOR RADIO WIRING ! THE AMPLIFIERS IN THIS RADIO ARE ONLY DESIGNED FOR USE WITH 4 SPEAKERS. ! NEVER COMBINE (BRIDGE) OUTPUTS FOR USE WITH 2 SPEAKERS. ! NEVER GROUND NEGATIVE SPEAKER LEADS TO CHASSIS GROUND. ! FAILURE TO WIRE EXACTLY AS SHOWN BELOW MAY CAUSE ELECTRICAL DAMAGE TO THE RADIO.
OPER AT ING INSTRUC OPERA INSTRUCTT IONS OPER AT ING INSTRUC OPERA INSTRUCTT IONS 27(FAR SIDE) 18, 35 31 33,34 (FAR SIDE) 19 21(FAR SIDE) 20 30 16 REL 11 22 23 38 39 9 OPEN TUN AF TA TP PTY MTL EON (AUX) MODE TAPE IN CD TUNER VOL ST LOUD PRESET UALIZER 3 4 5 6 7 MONO SCAN DISP 17 2 MUTE LO/DX LOUD PAUSE SCAN REPEAT SHUFFLE DISC-DN DISC-UP BAND 1 2 3 4 5 6 AMS SEL DIM 29 26, 40 24, 41 25, 42 36 37 1 12 32 28 8, 10 14 13 15 1 POWER ON/OFF AND DIM BUTTON M
To adjust the treble level (Equalizer function inactive), first select the Treble mode by pressing the SEL button so the TRE indication appears on the display panel. Within 5 seconds of choosing the Treble mode, press the VOL - button to decrease the treble response or the VOL + button to increase it as desired. The level will be shown on the display panel from a minimum TRE -10 to a maximum of TRE +10 (TRE 00 indicates flat response).
OPER AT ING INSTRUC OPERA INSTRUCTT IONS bn SCAN BUTTON This feature allows you to automatically sample each available station in the current band. When the button is pressed, the frequency will advance upward, stopping at each available station (depending on LO/DX mode) for 5 seconds. When a desired station is reached, press the SCAN button again to cancel the function and play of the selected station will continue.
The Vacuum Fluorescent Display (VFD) panel displays the frequency, time, and activated functions using one of three illumination levels as selected by the Power/DIM button 1. cl POWER LEVEL METER DISPLAY This display consists of left and right three-bar graphs which provide a visual representation of the volume level and the left and right channel audio signal levels. The volume level is represented by the two outer bar graphs. As the volume is increased, the number of illuminated segments will increase.
OPER AT ING INSTRUC OPERA INSTRUCTT IONS ct TIME/FREQUENCY SELECTOR (DISP) This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the radio frequency or CD player track indication is displayed, but the display can also show the time when this button is pressed. The time will then be displayed for approximately 5 seconds, after which it will return to the radio or CD player function display.
DISC SLOT DISC EJECT BUTTON FRONT PANEL FOLD-DOWN RELEASE BUTTON THEFT-DETERRENT LED AND RESET BUTTON (BEHIND FRONT PANEL MOUNTING PLATE) SPRING-LOADED FOLD-DOWN FRONT PANEL SET SETTT ING THE CLOCK 1. Turn the vehicle ignition and radio “on”. ct 2. Momentarily press the DISP button ; the time display will appear. Press and hold the DISP button for approximately 5 seconds (until the time display begins to flash). 3.
SPECIFICA SPECIFICATT IONS SPECIFICATIONS Size: 7" W x 2" H x 6-1/2" D 178 mm x 50 mmx 163 mm Operating Voltage: 12 volts DC, negative ground Output Power: 160 watts maximum (40 watts x 4 channels) Output Wiring: Floating-ground type designed for 4 speaker use. Front and rear channels CANNOT be combined (bridged) for use with 2 speakers. RCA low-level outputs (rear channels). Output Impedance: Compatible with 4/8-ohm speakers. Low-Level Output: 2.0 volts (2,000 mv.
Built into this radio are controls to operate an optional CD changer. Please check with your Rampage/Audiovox car stereo specialist or call 1-800645-4994 for recommendations of the models that will work with this radio. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio play. The following controls will operate the CD changer when it is installed and connected to this radio.
CD CH A NGER CONTR OL S/ERR OR CODES CHA CONTROL OLS/ERR S/ERROR en DISC/TRACK SHUFFLE PLAY SELECTOR When the SHUFFLE button is pressed, the SHF indication will appear on the display panel and the tracks on the disc will be played in a random, shuffled order. The Track Select button will also select tracks in the shuffled order instead of the normal progression.
The wireless remote control supplied with this model is capable of operating most of the features of the unit from a remote location. Each button on the remote control functions in the same way as the referenced button on the main unit. For optimal operation of the remote control, always aim it toward the Remote Sensor on the front panel of the main unit. dn 1 2 3 4 5 6 7 8 9 bl bm bn bo bp bq br bs POWER ON-OFF - See Main Unit VOLUME CONTROL ( VOL 1 / ) - See Main Unit 2, 3, 4, 5, 6 and 7.
INFR A RED REMO TE CONTR OL INFRA REMOTE CONTROL bt bu cl cm cn co cp CD PLAY/PAUSE (PAU) --See Main Unit cu bo LOCAL/DISTANT SELECT -- See Main Unit bs FM MONO/STEREO SELECT -- See Main Unit AUTOMATIC MEMORY STORE (AMS) - See Main Unit BAND/LOUD SELECTOR (BND/LOUD) – See Main Unit DISC UP (D.UP) SELECTOR -- See Main Unit bl and 8 ds DISC DOWN (D.DN) SELECTOR -- See Main Unit 1 bq dr 2 3 4 5 6 7 22 S 21 20 8 D U LOUD TR. DN 9 TR.
The radio section of your new sound system does not require any maintenance. We recommend that you keep this manual for reference on the many features found in this unit as well as how to set the clock. The compact disc player section also requires no routine maintenance, but proper understanding of its use and handling will help you obtain maximum enjoyment of its capabilities.
THIS PAGE INTENTIONALLY LEFT BLANK 18
WARRANTY 12 MONTH LIMI TED W A RR A NT Y LIMITED WA RRA AUDIOVOX CORPORATION (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company's option) without charge for parts and repair labor.
© 2001 Audiovox Electronics Corp.
