Owner's Manual

Page 8 of 11 Revision A 550-0426
1. Secure all harness wires in A-pillar.
a) Secure auto-dimming mirror harness wire(s) to vehicle harness
in A-pillar with 3 short tie wraps. (Fig. 34)
2. Bundle any excess harness wire(s) in kick-plate / cowl cover area
and connection wire / fuse block area and secure with remaining
short tie wraps. (Fig. 35)
1. Reconnect negative battery cable.
2. Turn the ignition switch ON/ACC position.
3. With the vehicle in a fairly well-lit area, perform the following:
a) To make sure the auto-dimming feature is on, verify that the
green LED to the left of the center switch is on. If it is not on,
push the button and hold for approximately 6 seconds
to turn
the green LED on.
b) Cover the forward looking photocell on the back of mirror with a
dark cloth or towel. (Fig. 36)
In a few seconds, the mirror will begin to darken.
NOTE: Time to darken will vary with ambient light level.
c) Remove the cover from the forward looking photo cell and the
mirror will begin to clear.
d) Verify that either a direction, such as NE, or “CAL” is displayed
in the display window. If not, ensure the feature is turned ON
by pressing and the button.
7. Testing is now complete.
5
Secure Harness Wires.
CCAUTION
!!
Ensure harness wires do not obstruct A-pillar airbag.
CCAUTION
!!
Do not secure harness wires to any airbag components in A-pillar.
CCAUTION
!!
Do not secure harness wires to any drain tubes in A-pillar
CCAUTION
!!
Ensure all wires being secured are clear of pedal and steering assemblies.
6
1R t ti btt bl
Testing.
CCAUTION
!!
34
35
36
CAUTION
!