User`s guide

7
ENGLISH
Connecting to Your TV
1.RunanRG6coaxialcablefromtheantenna
towardsyourtelevisionset.Connectthe
RG6coaxialcabletotheANTjackonthe
suppliedamplierinsert.
2.Connectbuilt-incoaxialcableonthe
amplierinserttotheantennainputjackon
yourTVorconverterbox.
Note: If you want to split the signal coming
from the antenna, connect the short coaxial
cable built into the amplifier insert to your
splitter (splitter sold separately). DO NOT
PUT THE SIGNAL SPLITTER BETWEEN THE
AMPLIFIER INSERT AND THE ANTENNA.
3.Afterallotherconnectionsaremade,
connect the power adapter into the
amplierinsert.PlugitintoastandardAC
outlet.
Important: This power adapter should be
plugged in so that it stays vertical or lays
flat.
The amplifier insert should always be
located indoors.
TV
ANT800
Coaxial Cable
Amplifier
Insert
ANTENNA
TV/STB
Water Damage Prevention:
Atthepointwhereyourcoaxialcableleadentersthehouse,youshould
allowforsomeslackinthecoaxialcableasa“driploop.”Thiswillprevent
moisturefromrunningdownthecoaxialcableandenteringthehouse.
Runthecoaxialcableapproximatelysixinchesbelowthewallentrypoint
andthenturnitupwardstowardsthisspot.Anymoisturethataccumulates
onthecoaxialcablewilldripoffinthebendinsteadofrunningintothe
house.Youshouldsealthepointwherethecableentersyourhomewith
arubberweatherinsulatororsiliconecaulking(notincluded).An“F”
connector wall plate can be used inside the home to cover the inside
portionofthehole.Youcantypicallyndan“F”connectorwallplateat
anylocalelectronicsorhardwarestore.