Specifications

Hooksett Fire –Rescue Department
Specifications for Stainless Steel Pumper Tanker Bid # 11-05
15
Bidder
Complies
Yes No
EXTERIOR WALL DIAMOND PLATE
The cab lower exterior rear wall shall be covered with a single sheet of bright aluminum treadplate to
protect the back of the cab from scratches.
FRONT WHEEL TRIM
The front axle shall be trimmed with mirror finish, 304L grade, non-corrosive stainless steel 'baby
moon' hub caps with an opening for viewing the oil seal cover, and bright finished nut covers.
REAR WHEEL TRIM
The rear axle(s) shall be trimmed with mirror finish, 304L grade non-corrosive stainless steel "Lincoln
Hat" hub cover and bright finished nut covers.
CAB PAINTED TWO-TONE
The chassis cab shall be painted two tone, Black roof and red lower half. (paint breaks lines to be
determined at preconstruction meeting)
CAB GROUND LIGHTING
One (1) light shall be mounted beneath each door. These lights shall be designed to provide
illumination on areas under the driver and officer area entry/egress. All cab ground lights shall
automatically activate when any cab exit door is opened and the parking brake is set.
A single switch shall be provided in the cab to activate all of the apparatus ground lights manually.
MULTIPLEX WIRING INTERFACE
The apparatus shall be equipped with a Class 1 ES-Key Management System for complete control of
the electrical system devices. No Exceptions
REFLECTIVE MATERIAL - INTERIOR CAB DOOR
The front cab doors shall have a minimum of 96 square inches of reflective material affixed to the
inside of each door.
CAB CONSOLE
There shall be a console installed in the cab between the two (2) front seats. The console shall be
fabricated from aluminum with a black powder coat finish and shall have the front portion of the top set
up for the master switch panel and the rear portion shall have a hinged lid that provides access to a
binder storage area with two dividers.
AIR INLET / OUTLET
An outside air system inlet/outlet connection shall be provided and mounted in an area beneath the
driver's door. This connection shall be clearly labeled as to the function. A pipe thread frame coupling
shall be provided with 1/4" npt threads. The fire department shall install the appropriate female hose
quick connect fitting.