Specifications

Hooksett Fire –Rescue Department
Specifications for Stainless Steel Pumper Tanker Bid # 11-05
18
Bidder
Complies
Yes No
performance the camera shall have a non-corrosive mounting bracket and stainless steel hardware.
The backup camera shall be mounted at the rear of the apparatus beneath the hosebed.
12VDC POWER POINT
A 12 volt, socket (cigarette lighter) type, receptacle shall be provided with a protective hinged cover.
The power point shall be wired to direct battery power with the appropriate wire size and fuse and
installed within reach of the officer.
12VDC POWER CIRCUIT
Dual circuit protected 30 amp battery "hot" circuit, a circuit protected 30 amp battery switched circuit,
and a ground circuit with the proper wire size to handle the current shall be provided. These circuits
are provided for two-way radio and/or accessory wiring.
The radio / accessory power circuit shall terminate in the console between the front seats.
RADIO ANTENNA MOUNT WIRING
Dual (2) NMO mount shall be roof mounted, one on the driver's side of the cab. & one on the officers
side of the cab. The coax is to be routed in the cab console
ROAD SAFETY KIT
One (1) 2-1/2# ABC DOT Approved fire extinguisher shall be provided and shipped loose with the
chassis.
One (1) set of DOT approved hazard triangles shall be supplied. They shall be stored in a plastic case
and shipped loose.
BATTERY CHARGER
Advanced electronic 4-step battery charger/power supply with a 40 amp output shall be installed in the
cab.
120-VOLT AC RECEPTACLE
A KUSSMAUL 120-volt AC electrical receptacle connection shall be installed beneath the driver's
door.
PUMP COMPARTMENT
The pump compartment shall be separate from the hose body and compartments so that each may
flex independently of the other. It shall be a fabricated assembly of stainless steel tubing, angles and
channels, which does not support the fire pump and or running boards. The pump compartment shall
be mounted onto the chassis through rubber mounts in a four point pattern to allow for a chassis frame
twist.
Pump compartment, pump, plumbing and gauge panels shall be removable from the chassis in a
single assembly and shall have an approximate width of 47". The pump compartment shall be of a