Specifications

Hooksett Fire –Rescue Department
Specifications for Stainless Steel Pumper Tanker Bid # 11-05
39
Bidder
Complies
Yes No
Belts
Brake P/N(chambers, ASA’s, Shoes, Drums)
Model & Serial #’s, Engine, Transmission, Axles, Pump
A permanent plate with pump performance data and serial numbers shall be installed on the pump
panel.
A permanent plate shall be installed in the driver's compartment specifying the maximum number of
personnel the vehicle is designed to carry per NFPA standards. It shall be located in an area visible to
the driver.
An accident prevention sign stating "DANGER PERSONNEL MUST BE SEATED AND SEAT BELTS
MUST BE FASTENED WHILE VEHICLE IS IN MOTION OR DEATH OR SERIOUS INJURY MAY
RESULT" shall be placed so it is visible from all seating positions.
An accident prevention sign stating "DANGER DO NOT RIDE ON REAR STEP WHILE VEHICLE IS
IN MOTION, DEATH OR SERIOUS INJURY MAY RESULT" shall be placed so it is visible from the
rear step of the vehicle.
WHEEL CHOCKS
One (1) pair of heavy duty, high tensile molded aluminum wheel chocks measuring 7.75" high x 8.5
wide x 15" long shall be provided with the apparatus. The wheel chocks shall have a bright yellow
powder coat finish for high visibility, safety and corrosion resistance. No exception shall be allowed to
these requirements.
Two Stainless steel chock holders shall be provided and mounted on the left side of the apparatus
below the front body compartment.
HARD SUCTION HOSE
Two (2) 15' long x 6" diameter TFT lightweight PVC flexible suction hose shall be provided. The hard
suction hose shall be equipped with a long handle female end and rocker lug male end couplings.
REFLECTIVE SAFETY STRIPE
A 1" x 6" x 1" wide 3M brand Scotchlite reflective stripe shall be affixed to the perimeter of the vehicle.
The striping shall be placed up to 60" above ground level and shall conform to NFPA reflectivity
requirements. At least 60% of the perimeter length of each side and width of the rear, and at least
25% of the perimeter width of the front of the vehicle shall have reflective stripe.
REFLECTIVE STRIPE COLOR
The apparatus 6” body striping shall be black reflective.
The 1” accent stripe(s) shall be gold reflective.
MISCELLANEUOS
There is included within this proposal a lettering allowance of $1500.00 for lettering as directed by the
Fire Department.
There shall be included within this proposal a $5,000.00 new equipment / equipment mounting
allowance to be expended as directed by the fire department.