Specifications

Proposal Number PSDF #P09-0004
 Officers side floor width 24-1/2 inches minimum
 The measurement across the floor from the rear wall to the first vertical portion of the engine
enclosure 39 inches
CAB DOORS
The cab entry and egress shall be designed for a firefighter in full turnout gear. Each door shall open a
minimum of ninety degrees to afford the firefighter maximum space.
The doors shall be of a flush design each having exposed, one-piece, polished stainless steel hinges. The
hinge shall be made of 12-gauge material with a minimum hinge pin diameter of 1/4 inch.
The door windows shall have interior and exterior glass weather seals to prevent the influx of exterior air.
The doors shall have exterior and interior paddle type latches for ease of opening with a gloved hand. The
paddle latches are to have a rubber gasket, on the outside, separating the handle from the finished painted
surface.
FRONT DOORS
The cab front doors shall be of the full-length design enclosing the entire step area of the cab. The door shall
be a minimum of 38-1/2 inches wide and 74 inches tall. The front door windows shall have a minimum of
712 square inch area of viewing glass per door. There shall be a fixed piece of forward glass in each of the
front doors.
ELECTRIC WINDOWS
The front (2) roll down door windows shall be equipped with electrically operated mechanisms to control the
opening and closing of the windows. Control shall be with a momentary switch near the door.
One (1) additional switch shall be supplied in the driver's door to control both of the power windows from
the driver's position.
REAR CAB DOORS
The rear cab doors shall be similar to the forward doors and shall be located directly behind the front wheel
well area. These doors shall be 74 inches high x 34 inches wide. Each door shall have a roll down rear
window with a minimum glass viewing area of 670 square inches.
REAR WINDOW SAFETY BARS
There shall be a one inch stainless steel grab bar installed on each rear door. This bar is to be installed on the
rear door frame even with the window in the down position to prevent firefighters from using the glass in the
door for a handle.
CAB DOORS - INTERIOR TRIM
To provided durability the interior of the cab doors shall be finished with full length aluminum panel that is
finished with Zolatone high abuse paint. Plastic, ABS or vinyl interior door panels are not acceptable
Page 109