Specifications

Proposal Number PSDF #P09-0004
STOP SIGN - INTERIOR CAB DOOR
A reflective stop sign shall be mounted on each cab door for a total of four (4). The stop sign area shall
contain a minimum of 96 square inches of reflective material and be centered on the door lower kick plate
area and shall be visible when the cab door is open to traffic.
INTERIOR DOOR LOCKS
All doors shall have door locks with interior controls and exterior keyed door locks. The installation shall be
in conformance with FMVSS 206, with specific adherence to 49 CFR 571.206 Section 4.1.3 requiring that
"Each door shall be equipped with a locking mechanism with an operating means in the interior of the
vehicle". All doors shall be keyed alike. The doors shall be equipped with appropriate safety interlocks to
prevent accidental locking of the doors when closed.
CAB GLASS
AS-1 safety laminate glass shall be used in a two piece, wrap around design, as large as possible windshield
area for maximum visibility. The windshield shall have the style of a one-piece assembly with the practical
installation of two pieces for lower replacement cost. The windshield shall be readily available from a
nationally recognized automotive glass manufacturer that maintains local distribution outlets.
All glass shall be tinted.
Bidder must state if the windshield glass is available from local glass suppliers or if it a manufacturer’s
exclusive.
All fixed glass shall be installed with a one-piece triple locked rubber lacing material. Due to long term
appearance two-piece chrome trim lock lacing is not desired.
CAB SIDE WINDOWS
Two AS-2 tempered glass, fixed side windows, 26-1/2" high x 16" wide shall be furnished, one on each side
behind the forward doors. All glass shall be tinted. These windows shall be installed with a one-piece triple
locked rubber lacing material.
SUNVISORS
The driver and officer side of the cab shall be equipped with a sun visor. The vinyl covered visors shall be a
minimum of 17-1/2" by 9".
WINDSHIELD WIPERS
Two speed electric pantograph wipers shall be installed. These wipers shall have minimum 24" blades and
have 28 1/2" wet arm electric pump washers. A 70 oz. Minimum windshield washer reservoir shall be
furnished.
INTERMITTENT WIPER CONTROL
A rotary combination intermittent electric wiper / washer switch shall be provided on the left hand side of the
driver's dash.
Page 110