Specifications

Proposal Number PSDF #P09-0004
REAR WORK LIGHTS
Two (2) recess mounted area work lamps shall be provided above the tailboard, one (1) each side on the
inner face of the beavertail. The lights shall be shall be switched on when the parking brake is set and the
apparatus is running with the master battery switch in the "ON" position.
UNDERBODY LIGHTING
Underbody ground lights shall be provided under the apparatus body as required by current NFPA 1901.
Four (4) Truck-Lite model #60 ground lights shall be provided at the rear of the apparatus body, two (2) each
side, to illuminate under the rear compartments.
There shall also be two (2) model #40 ground lights provided at the outer front corners of the apparatus body,
one (1) each side, to illuminate the area under the forward compartments and pump panel areas. All
underbody ground lights shall be switched on when the parking brake is set and the apparatus is running with
the master battery switch in the "ON" position.
FOLDING STEPS
Folding steps shall be provided on the front and rear of the apparatus body. Steps shall be provided and in
installed per NFPA requirements.
INTERMEDIATE REAR STEP - UPPER FULL WIDTH
An NFPA #1901 compliant rear step shall be located just above the rear compartment and span the width of
the hose bed. It shall be no less than 8" in depth and fabricated of aluminum or stainless steel.
INTERMEDIATE REAR STEPS - LOWER
Two (2) rear corner steps, one (1) each side, shall be located adjacent to the rear compartment and shall be no
less than 8" in depth and fabricated of aluminum or stainless steel to meet NFPA #1901 step requirements.
REAR HANDRAILS
Three (3) ribbed, solid stock 1-1/4" diameter, aluminum handrails with chrome plated stanchions shall be
supplied and installed at rear of the apparatus body. There shall be two (2) 24" long vertical handrails
installed, one (1) each side on the inside of the rear area of the body and one (1) 69" long handrail installed
horizontally along the upper edge of the beavertail area.
HARD SUCTION TRAY - LEFT SIDE
One (1) gray powder coated aluminum hard suction tray shall be installed on the left side of the apparatus.
The tray shall be designed to accommodate from three to six inch hard suction hose in a ten foot length and
employ a design without fasteners or clamps to hold the suction hose in place in the tray. The suction hose
shall be able to be removed by one person from the rear of the apparatus.
The tray shall be mounted on top of the high side compartment.
Page 153