Specifications

Proposal Number PSDF #P09-0004
One (1) 10' long x 6" diameter TFT lightweight PVC flexible suction hose shall be provided. It shall be first
quality, non-collapsible type and designed for having a low friction loss which will not collapse under a
vacuum of 23". The hard suction hose shall be equipped with a long handle female end and rocker lug male
end couplings.
HOSEBED FLOODLIGHT
One (1) Unity AG hosebed floodlight shall be mounted at the front right corner of the hosebed. The light
shall be controlled from a water proof switch on the lamp head.
CAB SIDE SCENE LIGHTS
There shall be side scene lights installed on the side of the cab between the front and rear cab doors on the
raised roof section.
The lighting position(s) shall have two (2) Federal Signal GHScene, dual lamp, 40 watt total per head scene
lights with adjustable lamps and a Federal Signal chrome trim.
The scene lights shall be operated by a switch located in the driver's area of the cab.
BODY REAR SCENE LIGHTS
There shall be rear scene lights installed as high as possible on both sides of the rear of the apparatus body.
The lighting position shall have two (2) Federal Signal GHScene or equal, dual lamp, 40 watt total per head
scene lights with adjustable lamps and a Federal Signal chrome trim.
The rear scene lights shall be operated by a switch located beneath the left rear step. If the scene light is left
in the 'ON' position the lights shall automatically turn off when the truck is parking brake is released.
APPARATUS BODY ELECTRICAL SYSTEM
All body electrical shall conform to NFPA 1901 latest edition standards. The apparatus shall be equipped
with a heavy-duty 12-volt negative ground system.
All 12-volt apparatus wiring shall pass through a heavy duty power disconnect solenoid. The 12-volt control
of the power disconnect switch is to be triggered by the Master Battery Disconnect.
The apparatus shall be equipped with a Class1 Es-Key Management System for complete control of the
electrical system devices.
The right rear compartment shall house a relay based Power Distribution Module (PDM). The PDM shall
contain 12 standard automotive relays. Each relay's output shall be monitored by the Es-Key system to
provide true on/off feedback. Each output shall be capable of handling up to 30 amps and be protected by an
automatic circuit breaker. The PDM shall be mounted on a removable panel in the left rear compartment
with sufficient harness length to allow a technician the ability to remove the PDM and place it on a
compartment shelf for diagnostics and service.
All wiring shall be color-coded and function coded to assist the technician in servicing the electrical system.
All circuits shall be divided and balanced for proper load distribution. Where possible, wiring shall be routed
Page 154