Specifications

Proposal Number PSDF #P09-0004
712 square inch area of viewing glass per door. There shall be a fixed piece of forward glass in each of the
front doors.
ELECTRIC WINDOWS
The front (2) roll down door windows shall be equipped with electrically operated mechanisms to control the
opening and closing of the windows. Control shall be with a momentary switch near the door.
One (1) additional switch shall be supplied in the driver's door to control both of the power windows from
the driver's position.
REAR CAB DOORS
The rear cab doors shall be similar to the forward doors and shall be located directly behind the front wheel
well area. These doors shall be 86 inches high x 34 inches wide. Each door shall have a roll down rear
window with a minimum glass viewing area of 670 square inches.
REAR WINDOW SAFETY BARS
There shall be a one inch stainless steel grab bar installed on each rear door. This bar is to be installed on the
rear door frame even with the window in the down position to prevent firefighters from using the glass in the
door for a handle.
CAB DOORS - INTERIOR TRIM
To provided durability the interior of the cab doors shall be finished with full length aluminum panel that is
finished with Zolatone high abuse paint. Plastic, ABS or vinyl interior door panels are not acceptable
STOP SIGN - INTERIOR CAB DOOR
A reflective stop sign shall be mounted on each cab door for a total of four (4). The stop sign area shall
contain a minimum of 96 square inches of reflective material and be centered on the door lower kick plate
area and shall be visible when the cab door is open to traffic.
INTERIOR DOOR LOCKS
All doors shall have door locks with interior controls and exterior keyed door locks. The installation shall be
in conformance with FMVSS 206, with specific adherence to 49 CFR 571.206 Section 4.1.3 requiring that
"Each door shall be equipped with a locking mechanism with an operating means in the interior of the
vehicle". All doors shall be keyed alike. The doors shall be equipped with appropriate safety interlocks to
prevent accidental locking of the doors when closed.
CAB GLASS
AS-1 safety laminate glass shall be used in a two piece, wrap around design with a minimum 3760 square
inches of windshield area for maximum visibility. The windshield shall have the style of a one-piece
assembly with the practical installation of two pieces for lower replacement cost. The windshield shall be
readily available from a nationally recognized automotive glass manufacturer that maintains local
distribution outlets.
Page 22