Specifications

Proposal Number PSDF #P09-0004
All glass shall be tinted.
All fixed glass shall be installed with a one-piece triple locked rubber lacing material. Due to long term
appearance two-piece chrome trim lock lacing is not desired.
CAB SIDE WINDOWS
Two AS-2 tempered glass, fixed side windows, 26-1/2" high x 16" wide shall be furnished, one on each side
behind the forward doors. All glass shall be tinted. These windows shall be installed with a one-piece triple
locked rubber lacing material.
SUNVISORS
The driver and officer side of the cab shall be equipped with a sun visor. The vinyl covered visors shall be a
minimum of 17-1/2" by 9".
WINDSHIELD WIPERS
Two speed electric pantograph wipers shall be installed. These wipers shall have minimum 24" blades and
have 28 1/2" wet arm electric pump washers. A 70 oz. Minimum windshield washer reservoir shall be
furnished.
INTERMITTENT WIPER CONTROL
A rotary combination intermittent electric wiper / washer switch shall be provided on the left hand side of the
driver's dash.
STEERING WHEEL AND COLUMN
The steering column shall be a DOUGLAS or equal tilt / telescopic type with an integral high beam / turn
signal control switch. The column shall have self-canceling design for the turn signal switch. A 4-way
warning "Hazard" light switch shall be mounted on the column. For safety, a rubber boot shall be installed to
cover the steering shaft from the dash to the floor.
The steering wheel shall be a minimum of 18-inch diameter, covered with a padded absorbite finish. A lever
on the left side of the steering column shall control the telescopic feature of the steering column.
FASTENERS
All cab exterior fasteners shall be stainless steel type fastened to the cab with nutserts.
BATTERY ACCESS
The rear cab steps shall have a removable kick panel, providing access to the batteries for routine
maintenance and inspection.
CAB CORROSION TREATMENT
The cab shall have a corrosion preventative material conforming to Mil Spec C-16173-C, Grade 1, applied
during and after construction. A 10-year warranty against perforation due to rust or corrosion shall be
Page 23