Specifications

Proposal Number PSDF #P09-0004
BATTERY CONDITIONER / CHARGER
A KUSSMAUL AUTO CHARGE 1200 battery charger shall be installed, under the driver's seat, for
charging the batteries. This charger shall include an integral bar graph display to indicate the condition of
the batteries. Automatic sensing of the battery condition shall stop charging when the batteries are fully
charged.
Specifications:
Input: 115 volts 50/60 Hz. 12 amps maximum
Output: 12 vdc 0-40 amps
SHORELINE AUTO-EJECT
A KUSSMAUL Super Auto Eject, model 091-55-20-120, with weatherproof cover shall be mounted on the
cab exterior immediately adjacent to the rear of the driver's door.
The Super Auto Eject is to be completely sealed to prevent internal contamination of the working
components.
The internal switch arrangement of the Super Auto Eject shall be designed to close and open the 120-volt AC
circuit after the mating connector is inserted and before the connector is removed. This design shall prevent
arcing at the connector contacts to provide long life.
The electrical connection shall be provided as a 120-volt AC - 20 amp type using a NEMA 5-20P connector.
ENGINE ENCLOSURE
The engine enclosure shall be covered to reduce engine noise and reduce inside temperature.
The under side of the engine enclosure shall be covered with a sandwiched material for interior cab noise and
heat rejection. This sandwiched acoustical material shall have one layer of 1/8" foam, a 3/16" single barrier
septum and a 7/8" layer of foam to provide on overall thickness of 1-3/16". The sandwich material shall be
chemically bonded to prevent layer separation. A finished surface treatment of metalized film shall be
provided on the engine side of the barrier. The acoustical barrier shall be held in place with mechanical
fasteners in addition to adhesive.
The insulation for protection from heat and sound shall keep the dBa level within the limits stated in the
current edition of NFPA 1901.
ACCESS FOR FLUID SERVICING
The engine enclosure shall have a hinged and latched panel to provide access to the engine lubricating oil
dipstick, power steering fluid reservoir dipstick and engine coolant recovery reservoir. This access shall
allow that these fluid levels can be checked and topped off, if required, without raising the cab.
INTERIOR CEILING PADDING AND TRIM
The cab front interior ceiling shall have a one-piece, removable, sound absorbing headliner to cover all
wiring and tubing used for lights and antenna leads.