Specifications

Proposal Number PSDF #P09-0004
REAR WALL COVERING
The rear interior wall of the cab shall have a two-piece, removable, wall covering to finish the interior trim,
cover all wiring and tubing used for lights and antenna leads.
FLOOR COVERING
The front and rear floor areas of the cab shall be covered with "HUSHCLOTH" sound barrier floormats.
This floormat shall be a three ply material with a 3/16" thick open cell isolation barrier of Polyurethane, a
3/32" thick closed cell Nitrile mid barrier for section reinforcement, and a 1/16" thick embedded pebbled
grain wear surface.
INTERIOR CAB STEP TRIM
The cab steps shall be completely enclosed behind each door. The toe kick surface shall be covered with
aluminum treadplate trim.
STEP LIGHTS
Four (4) Whelen OS Series LED step well lights shall be supplied. These lights, one in each step well, shall
be mounted at the top of the step directed downward toward the lower step. A chrome flange is to be
provided for each light. All step well lights shall be illuminated when any door is opened and the battery
selector is on.
GRAB HANDLES
One (1) additional molded grab handle shall be installed inside the cab. The handle shall be located on the
officer's side on the A Post.
Two (2) additional molded grab handles shall be installed in the cab. These handles shall be located one
each side on the B Posts side of the crew area doors.
RADIO COMPARTMENT WITH DOOR
Beneath the officer's seat there shall be a radio compartment with minimum interior dimensions of 19-1/2"
wide x 17" long x 7" high. This compartment shall have a side mounted diamond plate door mounted on a
piano hinge.
CAB STEP DIMENSIONS
The front cab steps shall have the following overall dimensional requirements:
 Driver's lower step size 10-1/4 inches deep minimum
 Driver's lower step size 29-1/2 inches front to back
 Officer's lower step size 10-1/4 inches deep minimum
 Officer's lower step size 29-1/2 inches front to back
Page 26