Specifications

Proposal Number PSDF #P09-0004
INTERMEDIATE CAB STEP
The cab shall have a full width intermediate "LaserGrip" anti slip inside step. The intermediate step shall be
approximately 9 inches from the top of the lower step to the top of the intermediate step.
INTERIOR CAB STEP TRIM
The cab steps shall be completely enclosed behind each door. No portion of the cab entrance step shall be
exposed when the door is in the closed position. The lower step shall be sealed from the under side of the cab
to eliminate road splash from entering the step area while the vehicle is driving. The horizontal step surfaces
shall be covered with bright aluminum tread plate meeting the requirements of NFPA-1901.
The vertical toe kick surface area of the cab step wells shall be covered with aluminum tread plate.
COMPARTMENT OPEN LIGHT
A Red Open Compartment Flashing Light, Whelen OS Series LED shall be mounted on the face of the
overhead panel. A chrome flange is to be supplied with the light.
This compartment open door light is wired with a flasher to the power panel for completion to the
compartment door open circuit on the body.
The compartment open light circuit shall be wired so that the light circuit is deactivated when the parking
brakes of the apparatus are applied.
A label shall be applied adjacent to the light 'DOOR OPEN'.
INTERIOR CAB LIGHTING
Four (4) step well lights shall be supplied. The lights shall be Whelen OS Series white LEDs with angled
chrome plated covers, one in each step well. All step well lights shall be illuminated when any door is
opened and the battery selector switch is on.
DOME LIGHTS
Two (2) red/clear LED clear dome lights shall be supplied. One light shall be installed in the front of the cab
centered over the engine doghouse. One light shall be installed centered over the rear crew area. These
lights shall be illuminated when any door is open or individually operated with a switch mounted on the light
and the battery switch is in the on position.
CAB HEATER / DEFROSTER
The in cab climate control system shall be installed beneath the dash on the officers side of the cab. This unit
shall include a three-speed blower, temperature control valve and a 44,000 BTU heater core.
The heater control shall be located on the doghouse mounted control center. The control shall have separate
on-off blower speed switch, thermostat control and outlet blend air switch.
There shall be one heat outlet with directional and flow control provided on the driver and one on the officer
side of the control center.
Page 27