Specifications

Proposal Number PSDF #P09-0004
12VDC TRIPLE POWER POINT
A triple outlet 12 volt, socket (cigarette lighter) type, receptacle shall be provided.
The power point shall be wired to switched battery power with the appropriate wire size and fuse.
The power point socket shall be provided, centered on the front area of the engine doghouse for use by the
driver and/or officer.
12VDC POWER CIRCUIT
A circuit protected 30 amp battery "hot" circuit, a circuit protected 30 amp battery switched circuit, and a
ground circuit with the proper wire size to handle the current shall be provided. These circuits are provided
for two-way radio and/or accessory wiring.
The radio / accessory power circuit shall terminate in the center of the cab on top of the engine doghouse.
HANDHELD SPOTLIGHT
An Optronics KB-4003 400,000 candlepower hand held spotlight shall be hard wired into the cab electrical
system and mounted convenient for the officer's use.
ROAD SAFETY KIT
One (1) 2-1/2# ABC DOT Approved fire extinguisher shall be provided. The fire extinguisher shall be
shipped loose with the chassis.
One (1) set of DOT approved hazard triangles shall be supplied with the chassis. They shall be stored in a
plastic case and shipped loose with the chassis.
EXTERIOR GRAB HANDLES
The cab shall have a bright anodized extruded aluminum 24" grab handles at each door position. The
aluminum shall be bright anodized for long service. Molded rubber gaskets shall be installed under the grab
handles to protect the painted surface of the cab.
FRONT GRILLE
A stainless steel front grille shall be installed on the front cab face. The front grille shall have a radiator rock
guard to assist in preventing damage to the radiator core.
The cab shall have one (1) engine "hot" air exhaust and one (1) engine air cleaner intake, on each side of the
cab. These openings shall be covered with a honey comb wire screen and shall have a bright polished
stainless steel outer grille.
CAB MUDFLAPS
Mud flaps shall be installed behind the front tires. These mud flaps shall be a minimum of 22" wide to
protect the underneath of the cab and body.
Page 34