Specifications

Proposal Number PSDF #P09-0004
APPARATUS FAMILIARIZATION
Fire Department personnel shall be instructed as to the use of the entire apparatus including, but not limited
to, chassis, fire pump system, the apparatus, and supplied equipment.
The familiarization specialist shall remain at the Fire Department for one (1) days (not less than eight (8)
hours), to provide instruction to all personnel, or as instructed by Chief of the Department. All meals, motel,
and travel costs shall be the responsibility of the successful bidder.
NFPA 4.3.2 After delivery of the fire apparatus, the purchaser shall be responsible for ongoing training of its
personnel to proficiency regarding the proper and safe use of the apparatus and associated equipment as
defined in NFPA 1002, Standard for Fire Apparatus Driver/Operator Professional Qualifications, and NFPA
1500, Standard on Fire Department Occupational Safety and Health Program.
DELIVERY DATA REQUIREMENTS
Delivery of the completed vehicle shall be no more than three-hundred twenty (320) calendar days after
acceptance of the formal contract by the successful proposer.
The manufacturer shall specify in his bid the number of calendar days after acceptance of the formal contract
by the manufacturer, that the completed vehicle shall be delivered to the purchaser. The manufacturer shall
not be held liable for damages arising from its failure to make or delay in making deliveries because of fire,
flood, riot, major component shortage, accidents, acts of God, or any circumstances beyond their control.
Information required at time of delivery to be supplied by the manufacturer:
A. Line set ticket showing parts used by the manufacturer in construction of the cab and chassis.
B. Electrical "as built" schematic booklet.
C. Air system "as built" schematic booklet.
D. Final build data sheet showing serial numbers for the following:
1) Cab and chassis Vehicle Identification Number
2) Engine
3) Transmission
4) Front axle
5) Rear axle(s)
6) Each tire showing mounting location on the chassis.
7) Apparatus Serial Numbers
E. Final build measurement data sheet showing the following:
1) Bumper extension
2) Wheelbase
3) Rear overhang
4) Cab measurements for the ground to the bottom of the cab at all four corners and the frame to cab
extreme at the frame height for all four corners of the cab.
5) Suspension measurements for the ground to the top of the frame at the centerline of the front axle
and the centerline of the rear axle or centerline of the tandem axles.
6) Overall Height, Length, and Width of completed body.
Page 6