Specifications

Proposal Number PSDF #P09-0004
COMPARTMENT VENTILATION
Each compartment shall be provided with a laser cut louver to provide adequate ventilation.
COMPARTMENT DIMENSIONS
All compartment dimensions are approximate and will vary with manufacturers. It is desired have as much
compartmentation as possible. Bidder must state the sizes and cu.ft. of each compartment bid.
Left Side
There shall be one (1) high side full depth compartment above the front outrigger. It shall have the
approximate dimensions of 31" wide x 33" high x 24" deep.
There shall be one (1) rescue style, full height, and full depth compartment ahead of the rear wheels. It shall
have approximate dimensions of 51" wide x 63" high x 24" deep.
There shall be one (1) high side full depth compartment ahead of the tandem centerline. It shall have
approximate dimensions of 53" wide x 33" high x 24" deep.
There shall be one (1) high side full depth compartment behind the tandem centerline. It shall have
approximate dimensions of 51" wide x 28" high x 24" deep.
There shall be one (1) rescue style, full height, and full depth compartment behind the rear wheels. It shall
have approximate dimensions of 27" wide x 58" high x 24" deep.
There shall be one (1) high side full depth compartment above the rear outrigger. It shall have the
approximate dimensions of 28" wide x 28" high x 24" deep.
Right Side
There shall be one (1) high side full depth compartment above the front outrigger. It shall have the
approximate dimensions of 31" wide x 33" high x 24" deep.
There shall be one (1) rescue style, full height, and full depth compartment ahead of the rear wheels. It shall
have approximate dimensions of 51" wide x 63" high x 24" deep.
There shall be one (1) low side full depth compartment behind the rear wheels. It shall have approximate
dimensions of 27" wide x 30" high x 24" deep.
There shall be one (1) low reduced depth compartment behind the rear outrigger. It shall have the
approximate dimensions of 18" wide x 30" high and 12" deep. This compartment shall be equipped with a
slam door for maximum compartment utilization.
ROLLUP DOORS
All compartments shall be provided with a roll up door that shall be constructed of double sided aluminum
extrusions connected with a ball and socket joint. The extrusions shall be 1-3/8" wide x 3/8" thick with satin
anodized finishing. A flexible EDPM extrusion shall be provided between each slat to insure a weather tight
Page 77