Specifications

Proposal Number PSDF #P09-0004
seal. Aluminum extrusions shall be individually replaceable without disassembling the entire door by
removing push out clips on each end.
The door latch shall be a non-locking stainless steel lift bar and shall be provided with a magnetic door ajar
switch system.
A Roll-Up door shall also be furnished on the ladder compartment.
FENDER SIDE SKIRTS
There shall be stainless steel fender side skirts located in the area of the rear wheels. The design of the
fender sides shall be a minimal length to provide maximum compartment space in the apparatus.
SCBA BOTTLE COMPARTMENTS
Eight (8) SCBA bottle tube compartments shall be provided, four (4) in each side rear wheel well area. Two
(2) shall be located forward and two (2) located rearward of each tandem axle tire. Each compartment shall
be provided with a hinged, cast aluminum door with a brushed finish.
FUEL FILL - REAR BODY
The fuel fill shall be located in the rear on the left side of the apparatus body. The spring loaded fuel fill
door shall have "Diesel Fuel" laser cut in the face of the door. There shall be a vent line from the fuel tank to
beneath the fuel cap to aid in fueling of the truck.
BODY FENDERS - POLISHED
The apparatus body fenders shall be made from 16 gauge polished stainless steel and shall be rolled, die
stamped and fully removable. The stainless steel fenders and stainless fender liners shall be fastened with
stainless bolts and ESNA nuts to the outer fender panel.
REAR AXLE MUD FLAPS
Two (2) black, anti-sail, mud flaps shall be mounted behind the rear wheels.
LONGITUDINAL APPARATUS BODY HOSEBED
There shall be a longitudinal hosebed furnished above the exterior right side lower body side compartments.
The hosebed shall be constructed in such a manner that shall prevent damage to fire hose. The hosebed shall
comply with the current NFPA requirements. The interior of the hosebed shall be free of projections such as
nuts, sharp edges or brackets that may damage hose. The hosebed and walls shall be manufactured from
stainless steel.
An aluminum extrusion shall be installed over the rear opening of the hosebed to protect the body from wear.
The hosebed bottom shall be fitted with removable slatted, ribbed 6" heavy-duty extruded aluminum
floorboards.
Page 78