Specifications

Proposal Number PSDF #P09-0004
BACKBOARD
One (1) Pro-Lite model PL-ONP, orange polyethylene backboard shall be provided and located in the
apparatus body.
OUTRIGGER COVER PANELS
Each out and down outrigger shall have a brushed stainless steel cover attached to the outer face. The cover
shall fit flush with the apparatus body when the outriggers are fully stowed.
OUTRIGGER WARNING LIGHTS
Four (4) red LED warning lights shall be mounted one on each out and down outrigger cover panel. These
lights shall activate when the outriggers are placed into motion.
DEEP ALUMINUM SHELVES - ADJUSTABLE
Four (4) adjustable aluminum shelves shall be furnished and installed and shall have a flange 1-1/2" deep
will be mounted in 24” deep compartments. Each shelf shall be adjustable in height and held in place by four
(4) extruded uprights.
ALUMINUM TRAY - PULL OUT
One (1) heavy duty pullout tray shall be installed on the floor of the compartment and shall be equipped with
Grant slides and a gas shock to hold the tray in both the in and out positions and shall be made from .190"
aluminum with a maximum capacity of 500 pounds.
ALUMINUM TRAYS - PULL OUT AND DOWN
Two (2) pullout and down trays shall be installed and shall be constructed of formed .190" aluminum with a
maximum capacity of 250 pounds. Each extrusion shall include a specially sized channel at both sides of the
drawer for the installation of two (2) high quality stainless steel ball bearing rollers. These bearings shall
provide support the outside front of each tray. A second set of stainless steel ball bearing rollers shall be
provided for the inside rear of each tray. These rollers shall be bolted to the rear of each drawer and shall
slide on two (2) extruded aluminum tracks that are angled to provide an "out and down" action of each tray.
Each drawer slide mechanism shall be mounted in Unistrut "C" channels to allow for future adjustment and
removal.
FULL HEIGHT PULL OUT VERTICAL TOOL BOARD
One (1) full height vertical pull out tool boards shall be installed in an exterior body compartment.
Each board shall be equipped with Grant slides and a gas shock to hold the board in both the in and out
positions.
The tool board shall be made from .25" aluminum and be fully adjustable across the width of the
compartment.
Page 81