Specifications

Proposal Number PSDF #P09-0004
TOOL BOX
A 20" long by 8" wide stainless steel toolbox with a top removable tray shall be provided with the apparatus.
The tool box shall be supplied with a logo of the truck manufacturer applied to the lower left front corner of
the box.
APPARATUS BODY ELECTRICAL SYSTEM
All body electrical shall conform to NFPA 1901 latest edition standards. The apparatus shall be equipped
with a heavy-duty 12-volt negative ground system.
All 12-volt apparatus wiring shall pass through a heavy duty power disconnect solenoid. The 12-volt control
of the power disconnect switch is to be triggered by the Master Battery Disconnect.
The apparatus shall be equipped with a Class1 Es-Key Management System or an approved equal, for
complete control of the electrical system devices.
The right rear compartment shall house a relay based Power Distribution Module (PDM). The PDM shall
contain 12 standard automotive relays. Each relay's output shall be monitored by the Es-Key system to
provide true on/off feedback. Each output shall be capable of handling up to 30 amps and be protected by an
automatic circuit breaker. The PDM shall be mounted on a removable panel in the left rear compartment
with sufficient harness length to allow a technician the ability to remove the PDM and place it on a
compartment shelf for diagnostics and service.
All wiring shall be color-coded and function coded to assist the technician in servicing the electrical system.
All circuits shall be divided and balanced for proper load distribution. Where possible, wiring shall be routed
in looms as a single harness. Heat resistant convoluted loom shall be used. Only solderless, insulated crimp
automotive electrical connectors shall be used.
CAB ICC MARKER LIGHTING
Five (5) amber Whelen OS Series LED cab face mounted clearance lights shall be supplied, mounted above
the windshield. These lights are to be mounted in a chrome flange.
Two (2) amber Whelen OS Series LED side clearance lights shall be supplied, one (1) each side mounted
ahead of the front door. These lights are to be mounted in a chrome flange.
An amber diamond shaped reflector shall be mounted on the lower corner of each cab front door adjacent to
the door hinge.
APPARATUS ICC MARKER LIGHTING
Two (2) amber Whelen OS Series LED side clearance lights shall be supplied, one (1) each side mounted
ahead of the forward body compartment. These lights are to be mounted in a chrome flange.
Five (5) red LED clearance lights shall be supplied, mounted in the rear of the apparatus.
Two (2) red LED clearance lights shall be supplied, mounted facing the side of the apparatus.
ICC lighting utilized and lighting positions shall be in conformance with FMVSS 108.
Page 82