Specifications

Proposal Number PSDF #P09-0004
12. Air compressor system lubricant.
13. Generator system lubricant.
A permanent plate with pump performance data and serial numbers shall be installed on the pump panel.
A permanent plate shall be installed in the driver's compartment specifying the maximum number of
personnel the vehicle is designed to carry per NFPA standards. It shall be located in an area visible to the
driver.
An accident prevention sign stating "DANGER PERSONNEL MUST BE SEATED AND SEAT BELTS
MUST BE FASTENED WHILE VEHICLE IS IN MOTION OR DEATH OR SERIOUS INJURY MAY
RESULT" shall be placed so it is visible from all seating positions.
An accident prevention sign stating "DANGER DO NOT RIDE ON REAR STEP WHILE VEHICLE IS IN
MOTION, DEATH OR SERIOUS INJURY MAY RESULT" shall be placed so it is visible from the rear
step of the vehicle.
If an inlet located at the pump operators position is valved, it shall be provided with a permanent label with
language per NFPA-1901, current edition.
WHEEL CHOCKS
One (1) pair of heavy duty, high tensile molded aluminum wheel chocks measuring 7.75" high x 8.5 wide x
15" long shall be provided with the apparatus. The wheel chocks shall have a bright yellow powder coat
finish for high visibility, safety and corrosion resistance. No exception shall be allowed to these
requirements.
Two chock holders shall be provided and mounted on the left side of the apparatus below the front body
compartment.
RADIOS
A Motorola model M28URS9PW1 M XTL 1500 mobile radio must be furnished and installed, along with a
G809 Analog, W484 3db Antenna, B-18 Speaker, G24 Two year Repair Service and Radio Programming.
A Motorola 16 channel VHF radio furnished and installed with antenna, speaker, programming.
CHASSIS PAINT
NOTE: Paint systems and applications will vary between manufacturers. Bidder shall furnish a top quality
Urethane paint ie. DuPont Imron
The frame and running gear shall be painted gloss black enamel. The running gear shall consist of the axles,
drivelines, air tanks, steering gear, frame mounted brackets, draglinks, and fuel tank.
The air system piping and electrical harnesses shall not be installed in the frame at the time of the frame
painting. This shall insure complete coverage of paint behind those areas, as well as to insure that the air
piping and wiring harnesses do not have paint applied to them, hindering troubleshooting.
Page 87