Specifications

shall be in the L1 compartment.

WEATHER RESISTANT TUBING

The AC wiring in the apparatus body shall be installed in seal tite weather resistant conduit.

SPARE LINE VOLTAGE BREAKER POSITIONS

There shall be two (2) spare 240-volt AC breaker positions accommodated for in the design and

installation of the line voltage breaker panel. No circuit breakers or additional wiring is provided

and the panel knock out will remain in place. These positions will be provided for future wiring

expansion by the department.

CIRCUIT BREAKERS

Manual reset 120 and 240-volt AC circuit breakers shall be provided in the load center as required

by the circuits installed by the apparatus manufacturer.

120 VAC RECEPTACLES

One 1 120-volt AC receptacle shall be provided in the upper rear of the following compartments.

L1,L4,R1,R4

The receptacles shall be mounted in a weather proof box with a self closing weatherproof cover.

The electrical outlet shall be a NEMA L5-15, rated at 120-volt AC, 15-amp, duplex twist lock

receptacle.

240 VAC RECEPTACLES

One 240-volt AC receptacles shall be provided with the apparatus. Each receptacle shall be located

in high the RR1 compartment shall be mounted in a weatherproof box with a self closing

weatherproof cover. The electrical outlet shall be a NEMA L14-30, rated at 120/240-volt AC 30-

amp, 4-wire, single twist lock receptacle.

CAB ICC MARKER LIGHTING

Five amber Whelen OS Series LED cab face mounted clearance lights shall be supplied, mounted

above the windshield. These lights are to be mounted in a chrome flange.

Two amber Whelen OS Series LED side clearance lights shall be supplied, one (1) each side

mounted ahead of the front door.

An amber diamond shaped reflector shall be mounted on the lower corner of each cab front door

adjacent to the door hinge.

APPARATUS ICC MARKER LIGHTING

Two amber Whelen OS Series LED side clearance lights shall be supplied, one each side mounted

ahead of the forward body compartment. These lights are to be mounted in a chrome flange.

Five red LED clearance lights shall be supplied, mounted in the rear of the apparatus.

Two red LED clearance lights shall be supplied, mounted facing the side of the apparatus.

ICC lighting utilized and lighting positions shall be in conformance with FMVSS.