Car Security System Owner's Manual

ManualsBrandsAudiovox ManualsAutomobile AccessoriesAPS-94FR

Owner's Manual

The transmitters included in the security system kit are pre-programmed at the

factory, with button # 1 assigned to channel one only. The suggested program

arrangement is listed below. To program channel 2 and 3, please follow the

programming instructions listed on pages two and three of this manual.

Transmitter Button Functions

Transmitter Programming Guide

Remote Arm/Disarm

Remote Emergency Panic

Door Lock/Unlock (Optional)

Pulsed Output

**(Optional Devices)

Switched Output

** (Optional Devices)

Button #2

Both Buttons

Factory Settings for Transmitter Buttons

Button Channel

System Function

Model APS-94FR

Button #1

* Third channel may be RF output only on some models.

** Some of the more common accessories for these channels are;

l AS 9075 Remote Car Starter l AS 9256 Remote Trunk Release Relay

l AS 9154 Remote Garage Door Interface l AS 9153 Remote Window Roll Up

Summary of content (6 pages)

PAGE 1
Model APS-94FR Owner's Manual Transmitter Programming Guide Transmitter Button Functions The transmitters included in the security system kit are pre-programmed at the factory, with button # 1 assigned to channel one only. The suggested program arrangement is listed below. To program channel 2 and 3, please follow the programming instructions listed on pages two and three of this manual.
PAGE 2
These factory programmed settings can be prioritized based on an individual's frequency of use, (i.e. pressing both buttons simultaneously to activate channel 1, arm/disarm etc.) by following the normal programming instructions below. Please note when changing the button sequences of the factory settings, it is necessary to perform steps 5, 9, and 12 three times using "transmitter A", followed by one time using "transmitter B".
PAGE 3
6. 7. 8. 9. 10. 11. 12. 13. Move the valet/bypass switch on, then off again. The dash mounted L. E. D. will flash 2 times, and the siren will "chirp" one time, indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc. You can assign any one of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2.
PAGE 4
BATTERY REPLACEMENT: The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can be used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. To replace the battery... 1. Remove the transmitter cover by removing the small screw from the back of the transmitter case. 2. Remove the discharged battery, making note of the orientation of the + and contacts, and dispose of properly. 3.
PAGE 5
ORDERING ADDITIONAL or REPLACEMENT TRANSMITTERS: Order Form for Additional 2 Button Transmitters Model: APS-94FR IMPORTANT: Read instructions below and legibly print all required infor mation. 1. Fill in the following information NAME ADDRESS ZIP CODE CITY STATE DATE PURCHASED WHERE PURCHASED 2. Enter the number of transmitters requried here 3. The cost per transmitter is $65.00 4. Enter total amount enclosed here $ (N.Y. State residents only: Include appropriate state sales tax) 5.