Installation Manual

128-9312

5 of 24

This Remote Start is to be used in vehicles with AUTOMATIC TRANSMISSIONS only! Although this sys-

tem is a sophisticated device with many advanced features, IT MUST NOT be installed into a vehicle with

a manually operated transmission. Doing so may result in serious personal injury and property damage!

INSTALLATION OF THE MAJOR COMPONENTS:

CONTROL MODULE: PART # 1365407

Select a mounting location inside the passenger compartment (up behind the dashboard). The mounting lo-

cation selected must be within 24" of the ignition switch wiring harness to allow connection of the 6 pin main

wiring harness. Be certain that the chosen location will not interfere with proper operation of the vehicle. Avoid

mounting the module to or routing the wiring around the steering shaft/column, as the module or wiring may

wrap around or block the steering wheel preventing proper control of the vehicle. The module will be secured

after all wiring is completed which will allow complete access until the job is done.

Do Not Mount The Module In The Engine Compartment, as it is not waterproof.

HOOD PIN SWITCH: PART # 1363699

The pin switch included in this package is intended for protecting the hood area of the vehicle. In all cases,

the switch must be mounted to a grounded metal surface. When the pin switch is activated (hood open), it will

supply a ground to the input wire activating the alarm. In addition, the hood switch is required for the safety

shut down of the remote start unit. If the vehicle is being worked on, this hood switch prevents the remote

start activation even if the RF command to start is issued.

This switch must be installed in all applications. Failure to do so may result in personal injury or

property damage.

THE PUSH-BUTTONPROGRAM SWITCH/LED/RECEIVER/ANTENNA ASSEMBLY: PART # 1181202

The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the

dashboard for maximum operating range. Choose a location above the belt line (dashboard) of the vehicle

for best reception. Special considerations must be made for windshield glass as some newer vehicles utilize

a metallic shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the antenna

toward a rear window location for best reception. Secure the antenna with the double stick tape provided.