Installation Manual

128-9312

11 of 24

Typical Vehicle Parking Lights

From Vehicle

Park Light Switch

White From

Remote Start Module

To + 12 Volts

(If Gnd. Switch See Note)

White/Red Wire From

Remote Start Module

15A

4 Pin Additional Harness: Parking Light Flasher I/O Alarm Bypass O/P & Ground P/N #1124294

1 Black Wire: Chassis Ground

Connect the Black Wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be

certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal.

2 White w/ Red Trace Wire: Parking Light Relay Input Wire

This wire is the common contact of the on board parking light asher relay. If the vehicle you are working on

has +12 Volt switched parking lights, connect this wire to a fused +12 Volt source. (Max. 15 Amps)

NOTE: If the vehicle's parking lights are ground switched, connect this wire to chassis ground.

3 Yellow w/ Black Trace Wire: (+) Output To Alarm Ignition Input

This is the positive output that will connect to an alarm system allowing the alarm to operate while under

control of the remote start. This wire can connect to an existing alarm system, or if available to the factory

alarm's ignition input.

4 White Wire: Parking Light Relay Output

This wire is the normally open contact of the on board parking light ash relay. Connect this wire to the

vehicle's parking light feed wire. This is the wire that gets switched on, either (+) or (-), when the vehicle's

parking light switch is activated.