Installation Manual

ManualsBrandsAudiovox ManualsRemote Start SystemsAudiovox APS15KB

128-9312

20 of 24

SELECTABLE FEATURES

The selectable features of this unit can be set manually as explained above, or online by using our web link. The Accessory VE-

PROG kit will include the necessary cables to connect to your computer along with the web access information and application

required to take advantage of this feature.

Factory default settings are indicated by BOLD text below.

NOTE: The method of manual override can either be selected to operate from the valet switch or operate by custom code. Custom

Code programming is found in the owners guide. Be certain to place a check mark indicating the method used in the box

located on the last page of the owner's manual.

NOTE: Manual programming Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.

Also, no data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection

will be available.

RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.

RF Programmable Features Bank 2 Is Alarm Selectable Features:

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps

1st DoorL/UL 500/500 mS 3.5 /3.5Sec. 500mS L, Dbl. U/L Dbl L, 500mS UL Dbl L, Dbl UL 500mS/350mS ul

2nd Accy Lock Not Available

3rd Accy. UL Not Available

4th Headlights Not Available

5th Passive Locks Not Available

6th Pass/Act Arm Not Available

7th Siren/Horn Not Available

8th Horn Chirp 10mS 16mS 30mS 40mS 50mS

9th O/R Method Not Available

10th 2 Step U/L Not Available

11th Chp Del Tx On Off

12th Trigger Circuits Not Available

13th L/UL Poll Not Available

14th Aux Ch 5 Sel Not Available

15th Aux Ch 6 Sel Not Available

16th Aux Ch 7 Sel Not Available

17th Trigger Delay Not Available

18th Data Port Select DBI Protocol ADS Protocol

1. If Programming via PC while connected to + 12VDC you must manually enter the programming mode as shown below.:

2. Turn the ignition on.

3. Press and release valet switch 3 times.

4. Turn ignition off then on, off then on, off then on, off then on to enter web/on-line feature selection Bank 5.

5. Siren chirps 5 times indicating access to feature program mode. Launch the application on your PC. Connect the module via the USB to DBI harness and

follow program prompts.