Installation Manual

128-9312

8 of 24

3 Dark Blue Wire: (-) 300mA Pulsed Channel 3 Output (Trunk)

The Dark Blue Wire supplies a 300mA ground pulsed output whenever channel three of the receiver is

accessed. Pressing the pre-programmed transmitter button for three seconds will access channel three.

This is a low current output and must be connected to a relay to supply power to the trunk release or the

circuit you wish to control. Connect the Dark Blue wire to terminal # 86 of a 30 amp automitive relay. Connect

terminal # 85 of the relay to a fused +12 Volt source. Connect the common, normally open, and normally

closed contacts of the relay to perform the selected function of channel 3.

4 Brown w/ Black Trace Wire: Positive Inhibit

The Brown w/ Black Trace Wire provides an instant shutdown for the Remote Start Control module whenever

it gets +12 Volts. If the Brake lights switch in the vehicle switches +12 Volts to the brake light circuit, connect

the Brown w/ BlackTrace Wire to the output side of the brake switch. This will allow the Remote Start to

shut down if an attempt is made to operate the vehicle without the key while running under the control of the

Remote Start. In most vehicles, in order to shift into gear, the brake pedal must be depressed. The brake

input will in turn cause the remote start unit to shut off.

5 Brown Wire: (+) Inhibit Shut Down

Any time +12 Volts is applied to the Brown Wire, the Remote Starter will be prevented from operating, even

if the signal is received from the transmitter. If there is a neutral start wire in the vehicle that switches +12

Volts when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle

wire to prevent starting while in gear.

6 Gray Wire: (-) Inhibit / Shut Down

Any time ground is applied to the Gray Wire, the Remote Starter will be prevented from operating, even if

the signal is received from the transmitter. If there is a neutral start wire in the vehicle that switches ground

when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle wire

to prevent starting while in gear.

If the vehicle you are working switches ground to the brake light circuit, this wire can be connected to the

output side of the brake switch. This will allow the Remote Start to shut down if an attempt is made to operate

the vehicle without the key while running under the control of the Remote Start. In most vehicles, in order

to shift into gear, the brake pedal must be depressed. The brake input will in turn cause the remote start

unit to shut off.

7 NA

8 Black w/ Yellow Trace Wire: Ground Output During Start (Crank)

The Black w/ Yellow Trace Wire will provide a 300 mA ground output while the starter output of the remote

start unit is active. This output can be used to activate the Crank Low/Bulb Test wire found in some GM

vehicles. This wire is also referred to as the ECM wake up wire in some vehicles.

NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement

is more than 300 mA. This output is also selectable and can perform an alternate function as shown

in feature selection Bank 3 Feature #20.